Toyota Camry

1996-2001 of release

Repair and operation of the car

Toyota Camry
+ 1. Maintenance instruction
+ 1.2. Information before driving of the car
+ 1.3. Independent maintenance
+ 1.4. Technical characteristics
+ 1.5. Several councils upon purchase of the car
+ 2. Maintenance
+ 3. Engines
+ 4. Cooling system
+ 5. Heating and ventilation
+ 6. Fuel system
+ 7. Exhaust system
+ 8. Transmission
+ 9. Running gear
- 10. Brake system
   10.2. Technical characteristics
   10.3. ABS system
   10.4. Blocks of disk brakes
   10.5. Brake support
   10.6. Brake disk
   10.7. Blocks of drum brakes
   10.8. Wheel cylinder of brakes
   10.9. Main cylinder of brakes
   10:10. Hoses and tubes of a hydraulic actuator
   10:11. Removal of air from a hydraulic actuator of brakes
   10:12. Vacuum amplifier of brakes
   10:13. Blocks of the parking brake of back disk brakes
   10:14. Parking brake
   10:15. Cables of the parking brake
   10:16. Braking signal switch
   10:17. ABS: natural choice
   10:18. Malfunctions of the brake system
+ 11. Body
+ 12. Electric equipment

10:10. Hoses and tubes of a hydraulic actuator

GENERAL INFORMATION

The condition of hoses and tubes is recommended to check each 6 months. At detection of cracks, dribbles, swellings and other damages replace a hose.

HOSES OF LOBBIES TOMOZOV

PERFORMANCE ORDER

1. Lift the car and remove a wheel.
	2. Turn out the tube union from a hose.
	3. Get a bracket of fastening of the union of a hose in an arm and pass a hose through an opening in an arm.
4. Turn off a bolt of the union and disconnect a hose from a support.
5. Remove a bracket from an arm of a rack and get a hose through an arm.
6. Pass a new hose through a rack arm, establish new copper laying, combine a ledge on a hose with an opening in a support and tighten an union bolt with the set moment.
7. Pass a hose in an arm, screw an union nut by hand.
8. Insert a bracket (if it is provided insert also cutting washer) and tighten an union nut with the set moment.
9. Remove air from support cylinders.
10. Establish a wheel and lower the car.

HOSES OF BACK TOMOZ

PERFORMANCE ORDER

1. Lift the car and remove a wheel.
	2. Turn out the tube union from a hose.
	3. Get a bracket of fastening of the union of a hose in an arm and pass a hose through an opening in an arm.
4. Remove air from the cylinder (support).

METAL TUBES

When replacing tubes track that on all route they were fixed by collars. The form of curved new tubes has to correspond to a form of replaced. Installation only of steel tubes, in accuracy corresponding to make of the car is allowed. Use of copper tubes is not allowed. Track that the tube lay at sufficient distance from moving or heated details.

After replacement of a tube remove air from a hydraulic actuator (see subsection 10.11.).