Toyota Camry

1996-2001 of release

Repair and operation of the car


Toyota Camry
+ 1. Maintenance instruction
+ 1.2. Information before driving of the car
+ 1.3. Independent maintenance
+ 1.4. Technical characteristics
+ 1.5. Several councils upon purchase of the car
+ 2. Maintenance
- 3. Engines
   - 3.1.2. Check of a compression
      3.1.3. Top Dead Point (TDP) of the N1 piston
      3.1.4. Cover of a head of cylinders
      3.1.5. Inlet collector
      3.1.6. Final collector
      3.1.7. Gas-distributing belt and asterisks
      3.1.8. Forward epiploon of a bent shaft
      3.1.9. Camshaft epiploon
      3.1.10. Camshafts and elevators of valves
      3.1.11. Head of cylinders
      3.1.12. Oil pallet
      3.1.13. Oil pump
      3.1.14. Flywheel / drive plate
      3.1.15. Back epiploon of a bent shaft
      3.1.16. Fastenings of the engine
   + 3.2. 6-cylinder two-row V6 3,0 engines of l
   + 3.3. Partition of engines
   + 3.4. Engine electric equipment
+ 4. Cooling system
+ 5. Heating and ventilation
+ 6. Fuel system
+ 7. Exhaust system
+ 8. Transmission
+ 9. Running gear
+ 10. Brake system
+ 11. Body
+ 12. Electric equipment


3beb1f2e



3.1.16. Fastenings of the engine
GENERAL INFORMATION

Typical fastenings of the 4-cylinder engine

1. The draft regulating engine shift
2. Back support of the engine
3. Mechanical transmission
4. Automatic transmission
 5. Fastening of a collector
6. Forward support of the engine
7. Engine arm

Check

PERFORMANCE ORDER
1. Lift and fix a forward part of the car. Establish a jack under the oil pallet.
2. Examine rubber shock-absorbers of support on existence of wear and damages, if necessary replace them.
3. Check that bolts of support were strong tightened.
4. Check whether support are worn-out.

Replacement

PERFORMANCE ORDER
1. Disconnect a wire of the minus plug of the accumulator. Lift and fix a forward part of the car.
2. To remove the right support, twist a nut and get a through bolt.
3. Twist the nuts fixing a support to an arm and remove a support.
4. To remove a back support, get three rubber stoppers and twist support nuts.
5. To remove a forward support, twist the nut fixing it to an engine arm, and unscrew three bolts fixing a support to a body.
6. Installation is made upside-down.