Toyota Camry

1996-2001 of release

Repair and operation of the car


Toyota Camry
+ 1. Maintenance instruction
+ 1.2. Information before driving of the car
+ 1.3. Independent maintenance
+ 1.4. Technical characteristics
+ 1.5. Several councils upon purchase of the car
+ 2. Maintenance
- 3. Engines
   - 3.1.2. Check of a compression
      3.1.3. Top Dead Point (TDP) of the N1 piston
      3.1.4. Cover of a head of cylinders
      3.1.5. Inlet collector
      3.1.6. Final collector
      3.1.7. Gas-distributing belt and asterisks
      3.1.8. Forward epiploon of a bent shaft
      3.1.9. Camshaft epiploon
      3.1.10. Camshafts and elevators of valves
      3.1.11. Head of cylinders
      3.1.12. Oil pallet
      3.1.13. Oil pump
      3.1.14. Flywheel / drive plate
      3.1.15. Back epiploon of a bent shaft
      3.1.16. Fastenings of the engine
   + 3.2. 6-cylinder two-row V6 3,0 engines of l
   + 3.3. Partition of engines
   + 3.4. Engine electric equipment
+ 4. Cooling system
+ 5. Heating and ventilation
+ 6. Fuel system
+ 7. Exhaust system
+ 8. Transmission
+ 9. Running gear
+ 10. Brake system
+ 11. Body
+ 12. Electric equipment


3beb1f2e



3.1.3. Top Dead Point (TDP) of the N1 piston
GENERAL INFORMATION

The highest point which is reached by the N1 piston at the time of a compression step is accepted to the top dead point.

The N1 piston is located in a forward part of the right number of cylinders from a gas-distributing belt.

PERFORMANCE ORDER
1. Disconnect a wire of the minus plug of the accumulator and if necessary unscrew spark plugs.
2. Remove an external cover of a gas-distributing belt.
3. Turn a bent shaft so that synchronizing tags of asterisks of camshafts were directed up and combined with cuts in a cover of a gas-distributing belt. On each asterisk there are two tags (see the table of the Tag of the camshaft).
4. Combine a tag on a pulley of a bent shaft (shooter) with the index on a casing of the oil pump. When tags are combined, the N1 piston is in VMT at the time of a compression step.

Camshaft tags

CAMSHAFT
TAG WHICH NEEDS TO BE USED
Final valves of the right head of cylinders
1
Inlet valves of the right head of cylinders
2
Inlet valves of the left head of cylinders
3
Final valves of the left head of cylinders
4