Toyota Camry
+ 1. Maintenance instruction
+ 1.2. Information before driving of the car
+ 1.3. Independent maintenance
+ 1.4. Technical characteristics
+ 1.5. Several councils upon purchase of the car
+ 2. Maintenance
- 3. Engines
+ 3.1.2. Check of a compression
- 3.2. 6-cylinder two-row V6 3,0 engines of l
3.2.2. Check of a compression
3.2.3. Top Dead Point (TDP) of the N1 piston
3.2.4. Covers of heads of cylinders
3.2.5. Inlet collector
3.2.6. Final collectors
3.2.7. Gas-distributing belt and asterisks
3.2.8. Forward epiploon of a bent shaft
3.2.9. Epiploons of camshafts
3.2.10. Camshafts and elevators of valves
3.2.11. Heads of cylinders
3.2.12. Oil pallet
3.2.13. Oil pump
3.2.14. Flywheel / drive plate
3.2.15. Back epiploon of a bent shaft
3.2.16. Fastenings of the engine
+ 3.3. Partition of engines
+ 3.4. Engine electric equipment
+ 4. Cooling system
+ 5. Heating and ventilation
+ 6. Fuel system
+ 7. Exhaust system
+ 8. Transmission
+ 9. Running gear
+ 10. Brake system
+ 11. Body
+ 12. Electric equipment
|
Removal
| PERFORMANCE ORDER |
|
1. Pit pressure in fuel system and disconnect a wire of the minus plug of the accumulator. |
|
TOP CAMERA OF THE COLLECTOR
| PERFORMANCE ORDER |
| 2. Merge cooling liquid. |
|
3. Unscrew two bolts (arrow) and uncover the engine. |
| 4. Remove the air filter. |
| 5. Disconnect wires and hoses from a throttle, disconnect a rope of a butterfly valve. |
|
6. Disconnect a tube of system of recirculation (shooter) of final gases from the camera. |
|
7. Remove two arms of the camera. |
|
8. Unscrew bolts (A) and twist the nuts (V) fixing the camera to the inlet collector located below and remove the camera. |
|
LOWER PART OF THE COLLECTOR
| PERFORMANCE ORDER |
| 2. Disconnect wires from fuel injectors. |
|
3. Disconnect a hose of a heater (A) and a hose of air supply (V) from a collector disconnect a fuel hose from the fuel highway. |
|
4. Unscrew bolts and twist nuts (arrow), remove the lower section of a collector – figures specified the sequence of tightening of bolts and nuts. |
|
5. Under the lower part of a collector the hose of cooling liquid (shooter) is located. If you removed an inlet collector, is strongly recommended to replace an old hose with new. |
|
Installation
| PERFORMANCE ORDER |
| 1. Carefully clean and wipe with acetone the joined surfaces of a collector and heads. |
| 2. Establish new laying and establish the lower section of a collector and tighten bolts till the required inhaling moment. |
| 3. Establish the remained details. |
|
|
|
