Toyota Camry
+ 1. Maintenance instruction
+ 1.2. Information before driving of the car
+ 1.3. Independent maintenance
+ 1.4. Technical characteristics
+ 1.5. Several councils upon purchase of the car
+ 2. Maintenance
- 3. Engines
+ 3.1.2. Check of a compression
+ 3.2. 6-cylinder two-row V6 3,0 engines of l
- 3.3. Partition of engines
3.3.1.2. 6-cylinder two-row engines
3.3.2. Capital repairs of the engine – general comments
3.3.3. Diagnostics of the engine by means of the vacuum gage
3.3.4. Capital repairs of the engine – an alternative
3.3.5. Auxiliary elements of the engine
3.3.6. Removal and installation of the engine
3.3.7. Engine partition
3.3.8. Head of cylinders and valves
3.3.9. Balancing device (4-cylinder engine)
3.3.10. Pistons and rods
3.3.11. Bent shaft
3.3.12. Block of cylinders
3.3.13. Honingovaniye of cylinders
3.3.14. Radical bearings and bearings of rods
3.3.15. Measurement of size of a free wheeling of the balancing device
3.3.16. Piston rings
3.3.17. Radical bearings of a bent shaft
3.3.18. Back epiploon of a bent shaft
3.3.19. Conrod bearings
3.3.20. Installation of the balancing device of the engine
3.3.21. It is rather live, than is dead …
3.3.22. Analysis of smoke of an exhaust
3.3.23. A gear belt for the gas distribution mechanism drive
3.3.24. Emergence in deposit oil
3.3.25. Engine overheat
+ 3.4. Engine electric equipment
+ 4. Cooling system
+ 5. Heating and ventilation
+ 6. Fuel system
+ 7. Exhaust system
+ 8. Transmission
+ 9. Running gear
+ 10. Brake system
+ 11. Body
+ 12. Electric equipment
3.3.13. Honingovaniye of cylinders
| GENERAL INFORMATION |
| The honingovaniye of cylinders requires the special abrasive tool. |
| After a honingovaniye on walls of the cylinder there has to be a pattern from the cross lines which are crossed at an angle approximately in 60 °. |
Special tools and skills therefore the best exit will be if you address experts are necessary for holding this procedure.
