Toyota Camry

1996-2001 of release

Repair and operation of the car

Toyota Camry
+ 1. Maintenance instruction
+ 1.2. Information before driving of the car
+ 1.3. Independent maintenance
+ 1.4. Technical characteristics
+ 1.5. Several councils upon purchase of the car
+ 2. Maintenance
+ 3. Engines
+ 4. Cooling system
+ 5. Heating and ventilation
+ 6. Fuel system
+ 7. Exhaust system
+ 8. Transmission
- 9. Running gear
   - 9.1.2. Technical characteristics
      9.1.3. Stabilizer of cross stability of a forward suspension bracket
      9.1.4. Rack of a forward suspension bracket
      9.1.5. Rack and spring of a suspension bracket
      9.1.6. Suspension bracket lever
      9.1.7. Spherical support
      9.1.8. Rotary fist and nave
      9.1.9. Nave and bearing of a forward wheel
      9.1.10. Stabilizer and plugs of the stabilizer of a back suspension bracket
      9.1.11. Rack of a back suspension bracket
      9.1.12. Longitudinal bar
      9.1.13. Levers of a back suspension bracket
      9.1.14. Nave and bearing of a back wheel
      9.1.15. Arm of a back suspension bracket
      9.1.16. Angles of installation of wheels
   + 9.2. Steering
   + 9.3. Half shafts
+ 10. Brake system
+ 11. Body
+ 12. Electric equipment

9.1.13. Levers of a back suspension bracket

Removal

PERFORMANCE ORDER

1. Lift a back part of the car and establish on supports, block forward wheels. Remove a back wheel.
	2. Disconnect a suspension bracket rack from an arm.
3. Remove average section of an exhaust pipe.
4. Turn off a nut and remove a bolt of fastening of the lever of a suspension bracket to an arm.
	5. Turn off the lower nut and remove a bolt of fastening of the lever to a suspension bracket cross-piece.
6. Remove the N2 lever.
	7. Remove collars of plugs of the stabilizer.
8. Remove terminal section of an exhaust pipe.
9. Remove the N1 lever.

Installation

PERFORMANCE ORDER

1. Installation of levers of a suspension bracket is carried out upside-down. Tighten all threaded connections with the set moments.

2. Establish a wheel.

3. Check and if necessary adjust the angles of installation of back wheels in car service.