Repair and operation of the Toyota Camry car - 5.2. Control panel of a heater and air conditioner//Toyota Camry of 1996-2001 /

Toyota Camry

1996-2001 of release

Repair and operation of the car



Toyota Camry
+ 1. Maintenance instruction
+ 1.2. Information before driving of the car
+ 1.3. Independent maintenance
+ 1.4. Technical characteristics
+ 1.5. Several councils upon purchase of the car
+ 2. Maintenance
+ 3. Engines
+ 4. Cooling system
- 5. Heating and ventilation
   5.2. Control panel of a heater and air conditioner
   5.3. Heater radiator
   + 5.4. Air conditioning system and heating
   5.5. Electric chain of coupling of the compressor of the air conditioner
   5.6. Moisture separator of the air conditioning system
   5.7. Compressor of the air conditioner
   5.8. Refrigerator of the air conditioning system
   5.9. Evaporator of the air conditioning system
+ 6. Fuel system
+ 7. Exhaust system
+ 8. Transmission
+ 9. Running gear
+ 10. Brake system
+ 11. Body
+ 12. Electric equipment



5.2. Control panel of a heater and air conditioner

Removal and installation
PERFORMANCE ORDER
1. Disconnect a wire of the minus plug of the accumulator.
2. Remove the central finishing panel and remove radio.
3. Remove handles of management and unscrew control panel screws (are specified by shooters).
4. Disconnect wires (are specified by shooters) from the control panel – the Avalon model.
5. Disconnect two ropes (are specified by shooters) from a back part of the control panel – the Avalon model. Remove the control panel.
6. Installation is carried out upside-down removals.

Adjustment of the operating ropes

PERFORMANCE ORDER
1. To adjust the rope operating the air inlet gate, install the lever in situation FRESH, establish and record a rope.
2. To adjust a rope the managing director of air mix, install the lever of air mix in position of COOL, establish and record a rope (it is specified by an arrow).

Check of an electric chain

PERFORMANCE ORDER
1. Check air conditioning system switch, having connected a tester to contacts 2 and 5. When the switch is transferred to position of ON, a chain between contacts 2-5 and 3-4 has to be closed.
2. Test the switch of the modes (see the table).
3. To replace any details of the control panel, remove handles (A), unscrew screws of a cover (V) and unscrew screws of switches (C).

Position of the handle of the switch
Contacts
Necessary condition
FACE
1 – 6
The chain is closed
B/L
1 – 5
The chain is closed
FOOT
1 – 4
The chain is closed
FOOT/DEF.
1 – 3
The chain is closed
DEF.
1 – 2, 7 – 8
The chain is closed