Toyota Camry

1996-2001 of release

Repair and operation of the car

Evaporator casing arrangement

1. Block of the delivery fan 2. Amplifier of the air conditioner (4-cylinder engines) 3. Adjusting valve 4. Amplifier of the air conditioner (6-cylinder models) 5. Electric motor of the delivery fan 6. Resistor of the negnetatelny fan 7. Thermoresistor 8. Heater radiator

9. Evaporator 10. Airoutlet gate servo-driver 11. Control panel of the air conditioner   – conditioner switch   – gearshift of the delivery fan   – switch of the modes 12. Block of the air conditioner

The casing of the evaporator is located under the central part of the dashboard, near the delivery fan.

Removal

PERFORMANCE ORDER

1. Lower pressure in system. 2. Disconnect a wire of the minus plug of the accumulator. 3. Disconnect two tubes of coolant (are specified by shooters) from a partition. 4. In models of 1999 for a detachment of tubes of coolant, the special tool is used. 1. Press from above. 2. Turn a rychazhok. 3. Pull up. 5. Merge cooling liquid and disconnect hoses from the heater block. 6. Remove finishing of the control panel and the control panel. 7. Disconnect wires from the evaporator and a casing of the delivery fan. 8. Remove the block of sockets of electric wires located in the lower part of the delivery fan. Remove clamps and an air pipe. Unscrew assembly bolts of a casing of the delivery fan (are specified by shooters). Remove the block of the delivery fan. 9. Unscrew the bolts fixing the broad valve to the evaporator. 10. Remove evaporator clamps, disconnect a drain hose and remove an evaporator casing. 11. Remove the thermostat sensor, unscrew screws and get the evaporator from a casing.

Installation

Installation is carried out upside-down removals.