Toyota Camry

1996-2001 of release

Repair and operation of the car

Toyota Camry
+ 1. Maintenance instruction
+ 1.2. Information before driving of the car
+ 1.3. Independent maintenance
+ 1.4. Technical characteristics
+ 1.5. Several councils upon purchase of the car
+ 2. Maintenance
+ 3. Engines
+ 4. Cooling system
+ 5. Heating and ventilation
- 6. Fuel system
   6.2. Technical characteristics
   6.3. Dumping of pressure in fuel system
   6.4. Fuel pump and pressure of fuel
   6.5. Fuel tubes and connections of tubes
   6.6. Removal and installation of the fuel pump
   6.7. Fuel pressure regulator
   6.8. Sensor of the index of level of fuel
   6.9. Fuel tank
   6.10. Cleaning and repair of the fuel tank
   6.11. Casing of the air filter
   6.12. Accelerator rope
   6.13. Electronic system of injection of fuel
   6.14. Throttle
   6.15. Fuel highway and injectors
+ 7. Exhaust system
+ 8. Transmission
+ 9. Running gear
+ 10. Brake system
+ 11. Body
+ 12. Electric equipment


6.14. Throttle


Four-cylinder engines

1. Vacuum hoses
2. Laying
3. A hose of the system catching fuel vapors
4. Casing of a butterfly valve
5. Wire of the sensor of provision of a butterfly valve
6. Wire
7. The pipe connecting a throttle to the air filter
8. Roundabout hose of cooling liquid
9. Air hose
10. Roundabout hose of cooling liquid
11. Rope of a butterfly valve
12. Accelerator rope
13. A hose of the system catching fuel vapors
14. Temperature sensor of system of recirculation of final gases.

Functioning of vacuum ports of a throttle – 4-cylinder models

Name of port
Other modes
there is no vacuum
there is no vacuum
there is no vacuum
there is no vacuum


1. Examine the lever mechanism, it has to function smoothly and not jam.
2. Start the engine, in turn disconnect vacuum hoses from a throttle. Check whether there is a vacuum idling and at higher turns. Compare results of check to data of the table Functioning of Vacuum Ports of a Throttle – 4-cylinder models.
3. Remove an airintaking pipe and check a throttle for existence of a deposit and dirt. If necessary wash out a throttle special solution for cleaning of carburetors.


1. Disconnect a wire of the minus plug of the accumulator.
2. Remove the airintaking pipe connecting the throttle case to the air filter.
3. Disconnect an accelerator rope from the lever of a butterfly valve.
4. Disconnect hoses and wires from a throttle casing.
5. Disconnect a wire from the sensor of provision of a butterfly valve.
6. Unscrew assembly bolts of a throttle.
7. Disconnect a throttle from an inlet collector.
8. Installation is carried out upside-down removals.