Toyota Camry

1996-2001 of release

Repair and operation of the car

Toyota Camry
+ 1. Maintenance instruction
+ 1.2. Information before driving of the car
+ 1.3. Independent maintenance
+ 1.4. Technical characteristics
+ 1.5. Several councils upon purchase of the car
+ 2. Maintenance
+ 3. Engines
+ 4. Cooling system
+ 5. Heating and ventilation
+ 6. Fuel system
+ 7. Exhaust system
+ 8. Transmission
- 9. Running gear
   + 9.1.2. Technical characteristics
   + 9.2. Steering
   - 9.3. Half shafts
      9.3.2. Removal and installation of half shafts
      9.3.3. Replacement of covers of a half shaft
+ 10. Brake system
+ 11. Body
+ 12. Electric equipment

9.3.2. Removal and installation of half shafts

Removal

Temporary fastening of a nave in need of rolling of the car at the removed half shafts

1. A washer (outer diameter is 50 mm)

2. A washer (outer diameter is 18–25 mm)

3. M14 nut

4. M14 bolt

PERFORMANCE ORDER

1. Disconnect the battery from weight.

2. Turn on the parking brake.

3. Take off a wheel cap (or naves), remove the forelock and a lock washer.

4. Release a nave nut.

5. Release wheel nuts, lift the car and remove a wheel.

6. Remove mud guards, turn off a nave nut.

7. Disconnect a spherical support from the lever (see subsection 9.1.7.).

8. Weaken a half shaft in a nave sharp blow through a brass pro-rate. If necessary remove a brake disk (see subsection 10.6.) and a stripper displace a half shaft.

9. Shoot a plastic casing with parts of cars, having turned off bolts.

10. Get a half shaft from a nave.

11. At removal of the right half shaft turn off a lock bolt of an intermediate support and remove a lock ring.

12. Get a half shaft from differential.

13. At removal of the left half shaft get the internal hinge of a half shaft from the check point.

14. If the car needs to be rolled at the removed half shafts, then fix a nave by a bolt with a nut.

Installation

PERFORMANCE ORDER

1. Installation is carried out upside-down.

2. Sharply push an internal part of a half shaft in order that the lock ring of differential came into a flute on the internal hinge.

3. Tighten a lock bolt of an intermediate support with the set moment.

4. At first tighten nuts of wheels, then a nave nut with the set moment, establish a lock washer and a zashplintuyta.

5. Believe oil level in the check point.

6. At detection of a side play or jamming of the bearing of an intermediate support replace a support (replacement is carried out in car service).