Toyota Camry
+ 1. Maintenance instruction
+ 1.2. Information before driving of the car
+ 1.3. Independent maintenance
+ 1.4. Technical characteristics
+ 1.5. Several councils upon purchase of the car
+ 2. Maintenance
+ 3. Engines
+ 4. Cooling system
+ 5. Heating and ventilation
+ 6. Fuel system
+ 7. Exhaust system
+ 8. Transmission
+ 9. Running gear
- 10. Brake system
10.2. Technical characteristics
10.3. ABS system
10.4. Blocks of disk brakes
10.5. Brake support
10.6. Brake disk
10.7. Blocks of drum brakes
10.8. Wheel cylinder of brakes
10.9. Main cylinder of brakes
10:10. Hoses and tubes of a hydraulic actuator
10:11. Removal of air from a hydraulic actuator of brakes
10:12. Vacuum amplifier of brakes
10:13. Blocks of the parking brake of back disk brakes
10:14. Parking brake
10:15. Cables of the parking brake
10:16. Braking signal switch
10:17. ABS: natural choice
10:18. Malfunctions of the brake system
+ 11. Body
+ 12. Electric equipment
|
Check
| PERFORMANCE ORDER |
| 1. Release nuts of wheels, lift the car and establish on supports. Remove wheels and wrap nuts of wheels into place to record a disk concerning a nave (to provide application of effort to a disk it is possible to dress washers). Release the parking brake (when working on a back brake). |
| 2. Remove a support (see subsection 10.5.), take aside and fix. Turn off bolts and remove a support arm. |
|
3. Check a condition of a disk on both sides. At detection of traces of deep development (depth more than 1,0 mm), remove a disk and a proshlifuyta. If when braking pulsations were noted, then the raised disk beating can be the cause. In the drawing – a disk with traces from the slips which are worn out to rivets. Replace a disk with such defects. |
|
4. Check a beating, having installed the arrow indicator in 13 mm from edge of a disk. If the beating on the indicator exceeds norm, then remove a disk and a proshlifuyta in car service. |
Prevention
|
|
The disk is recommended to be removed and ground periodically irrespective of indications of the indicator. At least it can be made by hand a small skin to reduce a roughness. |
|
|
5. After grinding thickness of a disk should not be less maximum permissible which is cast on a disk. The minimum thickness is specified on disk inside, near the place of fastening to a nave. |
|
6. Measure disk thickness in several places. |
|
Removal
| PERFORMANCE ORDER |
| 1. Turn off wheel bolts which temporarily fixed a disk, and remove a disk. |
|
|
| 2. If the disk of a back brake does not give in to removal, then turn off a cap, enter the screw-driver (the opening has to be at the very bottom) into an opening and rotating the regulator, take away blocks of the parking brake from a disk drum from the inside. |
|
3. Rotating the regulator, take away blocks of the parking brake from a disk drum (front view).
|
|
Installation
| PERFORMANCE ORDER |
| 1. Establish a back disk on hairpins. |
| 2. Establish an arm of a support and delay all fastenings with the set moment. |
| 3. Establish a support and tighten fastening bolts. If the hose of a brake was not disconnected, then it is not necessary to pump over brakes. |
| 4. Finalize a wheel, tighten nuts after lowering of the car. After assembly press several times a brake pedal. Check work of brakes. |
|
|
|
