Toyota Camry

1996-2001 of release

Repair and operation of the car

Toyota Camry
+ 1. Maintenance instruction
+ 1.2. Information before driving of the car
+ 1.3. Independent maintenance
+ 1.4. Technical characteristics
+ 1.5. Several councils upon purchase of the car
+ 2. Maintenance
+ 3. Engines
+ 4. Cooling system
+ 5. Heating and ventilation
+ 6. Fuel system
+ 7. Exhaust system
+ 8. Transmission
+ 9. Running gear
- 10. Brake system
   10.2. Technical characteristics
   10.3. ABS system
   10.4. Blocks of disk brakes
   10.5. Brake support
   10.6. Brake disk
   10.7. Blocks of drum brakes
   10.8. Wheel cylinder of brakes
   10.9. Main cylinder of brakes
   10:10. Hoses and tubes of a hydraulic actuator
   10:11. Removal of air from a hydraulic actuator of brakes
   10:12. Vacuum amplifier of brakes
   10:13. Blocks of the parking brake of back disk brakes
   10:14. Parking brake
   10:15. Cables of the parking brake
   10:16. Braking signal switch
   10:17. ABS: natural choice
   10:18. Malfunctions of the brake system
+ 11. Body
+ 12. Electric equipment

10:11. Removal of air from a hydraulic actuator of brakes

GENERAL INFORMATION

Need of pumping of a hydraulic actuator on all wheels arises after a detachment of tubes on the main cylinder of a brake or at strong lowering of the level of liquid in a tank.

When dismantling a hydraulic actuator of one wheel it is possible to be limited to removal of air only from the understanding cylinder.

If the highway from the main cylinder to wheel understood, then it is possible to be limited to removal of air only from this highway.

PERFORMANCE ORDER

1. On the stopped engine press several times a brake pedal that in the vacuum amplifier of brakes atmospheric pressure was restored.
2. Before pumping restore liquid level in a tank and during pumping support level, without allowing emptying of a tank. Fill in only fresh liquid.
3. Pumping of brakes should be carried out together. Prepare liquid, a vessel, a hose for pumping and a key for an union otvorachivaniye.
4. Begin pumping with a back right wheel. Unscrew the union for pumping and slightly tighten that it could be turned off without effort again.
	5. Attach a hose to the union, lower other end of a hose in a vessel with brake fluid.
6. Ask the assistant to press slowly a pedal of a brake and to hold.
7. Unscrew the union and later 2 sec. after the stream of the liquid following with bubbles weakens, tighten the union. Ask the assistant to release a pedal.
8. Repeat the procedure until in the following liquid vials of air do not cease to be observed. Tighten the union. Perform these operations in the sequence: left back wheel, the right forward, left forward. You watch liquid level in a tank.
9. Upon termination of pumping restore liquid level in a tank.
10. After pumping of brakes the pedal has to be "rigid". If necessary repeat the procedure of pumping.