Toyota Camry

1996-2001 of release

GENERAL INFORMATION

Details of the hummock drive of the parking brake

1. Hatch cover
2. An arm (cars with separate seats)
3. Cable of the N4 parking brake

4. Intermediate lever
5. Cable of the N1 parking brake
6. Plug
7. Intensifying section

Details of the hummock drive from a pedal to the intermediate lever

1. Cable of an otpuskaniye of the parking brake
2. Overlay of a pedal
3. Cable of the N1 parking brake
4. Bracket

5. Axis
6. Switch of a signal of the parking brake

Replacement

THE CABLE CONNECTING THE LEVELING LEVEL TO PARKING BRAKES OF BACK WHEELS

PERFORMANCE ORDER

1. Lift a back part of the car.
2. Release the parking brake and remove a drum (disk).
3. On the car with back drum brakes remove blocks and disconnect a cable from the block drive lever. On the cars equipped with back disk brakes remove blocks of the parking brake and disconnect the block drive lever.
	4. Turn off bolts of a tip of a cable of the parking brake on a brake board.
	5. Turn off a bolt of fastening of an arm of a cover of a cable. The arm of a cover of a cable is located in a forward part of a bar of a back suspension bracket (on a part of cars the arrangement of an arm can differ a little).
6. Remove average section of an exhaust pipe (or its priopustita) to provide access to cables.
	7. Turn off a bolt of fastening of a collar of a forward tip of a cover of a cable and bring a tip out of a collar.
	8. Turn a cable so that the tip of a cable left gearing with a level of the equalizer and unhook a cable.
9. Installation is carried out upside-down.
10. Adjust a cable.

THE CABLE CONNECTING THE INTERMEDIATE LEVER TO THE LEVELING LEVEL

PERFORMANCE ORDER

1. Remove the central section.
2. Release the lever of a brake and turn off a lock-nut and adjusting nuts. Disconnect a cable from the lever.
3. Working under the car, give a cable back, turn on 90 ° and extend a cable, having passed through an opening in a floor.
4. Installation is carried out upside-down. Grease the rubbing parts of a tip of a cable in a leveling level. Adjust a cable.

THE CABLE CONNECTING THE INTERMEDIATE LEVER TO THE PEDAL (ONLY FOR THE AVALON MODELS)

PERFORMANCE ORDER

1. Remove a front seat.

2. On the car with a seat of skameechny type remove intensifying section, on the car with separate seats remove the central section.

3. Disconnect a cable from the intermediate lever.

4. Remove the knee buffer of safety (see subsection 11.23.).

5. Disconnect the switch of a signal of the parking brake.

6. Rasshplintuyte also get a pedal axis, disconnect a cable from a pedal.

7. Installation is carried out upside-down.