Toyota Camry

1996-2001 of release

Repair and operation of the car


Toyota Camry
+ 1. Maintenance instruction
+ 1.2. Information before driving of the car
+ 1.3. Independent maintenance
+ 1.4. Technical characteristics
+ 1.5. Several councils upon purchase of the car
+ 2. Maintenance
+ 3. Engines
+ 4. Cooling system
+ 5. Heating and ventilation
+ 6. Fuel system
+ 7. Exhaust system
+ 8. Transmission
+ 9. Running gear
- 10. Brake system
   10.2. Technical characteristics
   10.3. ABS system
   10.4. Blocks of disk brakes
   10.5. Brake support
   10.6. Brake disk
   10.7. Blocks of drum brakes
   10.8. Wheel cylinder of brakes
   10.9. Main cylinder of brakes
   10:10. Hoses and tubes of a hydraulic actuator
   10:11. Removal of air from a hydraulic actuator of brakes
   10:12. Vacuum amplifier of brakes
   10:13. Blocks of the parking brake of back disk brakes
   10:14. Parking brake
   10:15. Cables of the parking brake
   10:16. Braking signal switch
   10:17. ABS: natural choice
   10:18. Malfunctions of the brake system
+ 11. Body
+ 12. Electric equipment


3beb1f2e



10.9. Main cylinder of brakes
GENERAL INFORMATION

Details of fastening of the main cylinder
1. Main cylinder
2. Laying
3. Vacuum amplifier
 4. Tee splitter
5. A splitter (on the car without ABS system)

Removal
PERFORMANCE ORDER
1. Disconnect the socket from a tank.
2. Remove liquid from a tank.
3. Spread rags under the main cylinder.

4. Turn off the union of tubes on the cylinder.
5. Get tubes from unions and take aside.
6. Turn off nuts of fastening of the cylinder to the vacuum amplifier and remove the cylinder.

Installation
PERFORMANCE ORDER
1. Remove air from the cylinder for what clamp the cylinder in a vice for an assembly flange.
2. Screw two tubes in the cylinder, having lowered them in a tank.
3. Fill the cylinder with liquid of the recommended brand.
4. Slowly press the piston, using, for example the big cross screw-driver, and release.
5. Repeat these actions until tubes do not cease to come out air.
6. Remove tubes one for another, rolling caps on their place.
7. Install the cylinder into place and wrap nuts by hand.
8. Screw the union without distortions, manipulating the cylinder.
9. Tighten a nut and the union.
10. Add liquid in a tank and remove air from a hydraulic actuator (see subsection 10.11.). Air can be removed from the cylinder also on the car, working together. For this purpose ask the assistant to press a pedal several times and to hold. Unscrew the union and let out the air. Wrap the union and ask the assistant to release a pedal. Continue so far liquid will not begin to follow from the cylinder. At this way lay space under the cylinder rags.
11. Check work of brakes.