Toyota Camry

1996-2001 of release

Repair and operation of the car

Toyota Camry
+ 1. Maintenance instruction
+ 1.2. Information before driving of the car
+ 1.3. Independent maintenance
+ 1.4. Technical characteristics
+ 1.5. Several councils upon purchase of the car
+ 2. Maintenance
+ 3. Engines
+ 4. Cooling system
+ 5. Heating and ventilation
+ 6. Fuel system
+ 7. Exhaust system
+ 8. Transmission
+ 9. Running gear
- 10. Brake system
   10.2. Technical characteristics
   10.3. ABS system
   10.4. Blocks of disk brakes
   10.5. Brake support
   10.6. Brake disk
   10.7. Blocks of drum brakes
   10.8. Wheel cylinder of brakes
   10.9. Main cylinder of brakes
   10:10. Hoses and tubes of a hydraulic actuator
   10:11. Removal of air from a hydraulic actuator of brakes
   10:12. Vacuum amplifier of brakes
   10:13. Blocks of the parking brake of back disk brakes
   10:14. Parking brake
   10:15. Cables of the parking brake
   10:16. Braking signal switch
   10:17. ABS: natural choice
   10:18. Malfunctions of the brake system
+ 11. Body
+ 12. Electric equipment


10:16. Braking signal switch


Braking signal switch

1. Pedal height

2. Pusher

3. Braking signal switch

The switch of a signal of braking is mounted on an arm near the top part of a pedal.

Removal and installation

1. Disconnect the battery from weight, disconnect the conducting socket from the braking signal switch.
2. Release a lock-nut and turn out the switch from an arm.
3. Installation is carried out upside-down.


1. Check and if necessary adjust pedal height. See subsection 2.23.
2. Release a lock-nut and rotate the switch so that the vystupaniye of a plunger And met standard (see subsection 10.2.). If it is impossible to check a vystupaniye, then adjust position of the switch so that the plunger slightly concerned the brake pedal limiter. Tighten a lock-nut.
3. Attach wires to the switch, connect the battery to weight. Check operation of the switch. Signals of braking have to light up when pressing a pedal and die away at a pedal otpuskaniye. Otherwise repeat adjustment.
4. Check and if necessary adjust a free wheeling of a pedal. See subsection 2.23.