Toyota Camry

1996-2001 of release

Repair and operation of the car

Toyota Camry
+ 1. Maintenance instruction
+ 1.2. Information before driving of the car
- 1.3. Independent maintenance
   1.3.1.2. Choice of engine oil
   1.3.1.3. Check of level of cooling liquid of the engine
   1.3.1.4. The choice like coolant
   1.3.1.5. Check and replacement of the filter of the air conditioner
   + 1.3.2. Wheels and tires
   + 1.3.3. Electric components
   1.3.4. Water additive in a washer tank
   - 1.3.5. Replacement of lighting lamps
      1.3.5.2. Parking light signals
      1.3.5.3. Side light signals
      1.3.5.4. Back light signal of turn, stoplight, back light signals
      1.3.5.5. Back fog lights
      1.3.5.6. Illumination of registration plate
      1.3.5.7. Highly established light stoplight
      1.3.5.8. Forward light signals of turns
+ 1.4. Technical characteristics
+ 1.5. Several councils upon purchase of the car
+ 2. Maintenance
+ 3. Engines
+ 4. Cooling system
+ 5. Heating and ventilation
+ 6. Fuel system
+ 7. Exhaust system
+ 8. Transmission
+ 9. Running gear
+ 10. Brake system
+ 11. Body
+ 12. Electric equipment

1.3.5. Replacement of lighting lamps

1.3.5.1. Headlights

GENERAL INFORMATION

Prevention

Halogen lamps have the elevated pressure of gas inside and demand the special address. They can become torn or break if are scratched or will fall. You hold a lamp only for its plastic or metal case. Do not touch a glass part of a lamp barehanded.

When replacing a lamp be convinced that switches of ignition and light are switched off. Use lamps with the rated power in watts specified in the table.

Lighting lamps	W	Type
Headlights	60/55	A
Forward fog lights	55	In
Parking light signals	5	D
Forward light signals of turns	21	With
Side light signals of turns	5	D
Back light signals of turns	21	D
Back fog lamp	21	D
Light stoplights and back light signals	21/5	D
Light signals of a backing	21	D
Illumination of registration plate	5	D
Highly established light stoplight	18	D
Personal illumination	10	With
Internal lighting	10	Е
Distinctive bulbs	1,5	Е
Illumination of a glove box	1,2	D
Illumination of a luggage carrier	3,8	D
A: Halogen lamps of HB2
B: Halogen lamps of H3
C: Unary face lamps
D: Wedge-shaped basic lamps
E: Dual face lamps

Replacement of headlights

Open a cowl. Disconnect a connector. Remove a rubber cover.

If connector to hard, then its poshatayta.

Release the fixing spring of a lamp and remove a lamp. Establish a new lamp and fix the fixing lamp spring.

For installation of a lamp combine lamp ears with a cut in an assembly opening.

Establish a rubber cover by a tag of "TOP" in the direction up and press a ledge. Insert a connector.

Make sure that the rubber cover densely adjoins to a connector and the case of a headlight.

Aiming is unnecessary after replacement of a lamp. If aiming performance is required, contact the dealer of Toyota.