Toyota Camry

1996-2001 of release

Repair and operation of the car

Toyota Camry
+ 1. Maintenance instruction
+ 1.2. Information before driving of the car
+ 1.3. Independent maintenance
+ 1.4. Technical characteristics
+ 1.5. Several councils upon purchase of the car
+ 2. Maintenance
+ 3. Engines
+ 4. Cooling system
+ 5. Heating and ventilation
+ 6. Fuel system
+ 7. Exhaust system
- 8. Transmission
   + 8.1.2. Care of MKPP
   - 8.2. Automatic transmission
      8.2.2. Technical characteristics
      8.2.3. Care of the automatic transmission
      8.2.4. General diagnostics
      8.2.5. Gear shifting lever rope
      8.2.6. Rope of a butterfly valve
      8.2.7. Switch of blocking of ignition
      8.2.8. System of blocking of the lever of gear shifting
      8.2.9. Replacement of epiploons
      8.2.10. Removal and automatic transmission installation
      8.2.11. Electronic control system
      8.2.12. "Automatic machine"
   + 8.3. Coupling
+ 9. Running gear
+ 10. Brake system
+ 11. Body
+ 12. Electric equipment

оборудование фирмы овен.

8.2.5. Gear shifting lever rope

Adjustment

PERFORMANCE ORDER

1. Lift and fix a forward part of the car.

2. Remove the protective guards closing space a boundary a forward part of the car and the lower cross-piece.

3. Weaken a nut of the switching lever on the transmission (it is specified by an arrow).

4. Install the switching lever in parking situation (against the stop up), and then on two clicks down in neutral situation (4-cylinder models, the A140E transmission).

5. Install the switching lever in parking situation (against the stop down), and then on two clicks up (6-cylinder models, the A541E transmission).

6. Install the gear shifting lever in salon in neutral situation.

7. Tighten a lock nut.

8. Check how the lever of switching and the transmission functions.

Replacement

PERFORMANCE ORDER

1. Disconnect a rope from the switching lever on the transmission (the nut is specified by an arrow).

2. Remove the big clamp of a rope (is specified by an arrow) located over the lever. Disconnect a rope from an arm.

3. Unscrew the rope clamp bolts (are specified by shooters) located on a dividing partition.

4. Remove the central panel.

5. Remove a big clamp of a rope.

6. Remove a wire clamp, beat out a lock pin (it is specified by an arrow) and disconnect a rope from the gear shifting lever.

7. Remove a rope.

8. Installation is carried out upside-down removals.