Toyota Camry
+ 1. Maintenance instruction
+ 1.2. Information before driving of the car
+ 1.3. Independent maintenance
+ 1.4. Technical characteristics
+ 1.5. Several councils upon purchase of the car
+ 2. Maintenance
+ 3. Engines
+ 4. Cooling system
+ 5. Heating and ventilation
+ 6. Fuel system
+ 7. Exhaust system
+ 8. Transmission
- 9. Running gear
+ 9.1.2. Technical characteristics
- 9.2. Steering
9.2.2. Steering wheel
9.2.3. Tips of steering drafts
9.2.4. Covers of the steering mechanism
9.2.5. Steering mechanism
9.2.6. Pump of the hydraulic booster
9.2.7. Removal of air from a power steering contour
+ 9.3. Half shafts
+ 10. Brake system
+ 11. Body
+ 12. Electric equipment
|
Steering mechanism and details of its installation
|
1. Protective panel of the left wing
2, 3. Forelock
|
4. Protective panel of the right wing
5. Stabilizer bar |
Removal
Prevention
At dismantle of the steering mechanism take measures excluding turn of a steering shaft, otherwise it is possible to damage a spiral wire of a safety cushion. For this purpose transfer the ignition key to situation "Parking", or wind a wheel with a seat belt and insert a wheel buckle into the lock.
| PERFORMANCE ORDER |
| 1. Establish wheels in the provision of driving on a straight line. Lift a forward part of the car and establish on supports. Turn on the parking brake and remove both forward wheels. Remove protective panels of a case of the engine (if are provided). |
|
2. Turn off the union of pressure head and return tubes of the hydraulic booster. Muffle tubes. Remove an arm from the steering mechanism. |
|
3. Designate mutual orientation of the lower cardan hinge of a steering shaft and shaft of the steering mechanism. Turn off a coupling bolt and a nut of a collar (arrow). |
| 4. Disconnect steering drafts. |
| 5. Turn off bolts of fastening of collars of plugs of the stabilizer (for access to bolts of the steering mechanism). |
| 6. Turn off nuts of fastening of the steering mechanism, raise a bar of the stabilizer and beat out bolts of fastening of the steering mechanism. |
| 7. Separate an intermediate shaft from a shaft of the steering mechanism and get the steering mechanism on the right side of the car. |
| 8. Check a condition of rubber plugs via which the steering mechanism fastens. In need of the plug replace. |
|
Installation
| PERFORMANCE ORDER |
| 1. Install the steering mechanism and attach the cardan hinge, having combined the tags put when dismantling. |
| 2. Turn and tighten bolts and nuts of fastening of the steering mechanism with the set moment. |
| 3. Attach steering drafts. |
| 4. Tighten a coupling bolt of a collar of the cardan hinge. |
| 5. Attach tubes of the hydraulic booster and tighten the union. |
| 6. Establish a stabilizer bar. |
| 7. Lower the car and remove air from a power steering contour. |
|
|
|
