Toyota Camry

1996-2001 of release

Repair and operation of the car

Toyota Camry
+ 1. Maintenance instruction
+ 1.2. Information before driving of the car
+ 1.3. Independent maintenance
+ 1.4. Technical characteristics
+ 1.5. Several councils upon purchase of the car
+ 2. Maintenance
+ 3. Engines
+ 4. Cooling system
+ 5. Heating and ventilation
+ 6. Fuel system
+ 7. Exhaust system
+ 8. Transmission
- 9. Running gear
   + 9.1.2. Technical characteristics
   - 9.2. Steering
      9.2.2. Steering wheel
      9.2.3. Tips of steering drafts
      9.2.4. Covers of the steering mechanism
      9.2.5. Steering mechanism
      9.2.6. Pump of the hydraulic booster
      9.2.7. Removal of air from a power steering contour
   + 9.3. Half shafts
+ 10. Brake system
+ 11. Body
+ 12. Electric equipment

9.2.7. Removal of air from a power steering contour

GENERAL INFORMATION

It is necessary to remove air from a wheel hydraulic actuator at any dismantling of the highway, irrespective of those measures against air hit which were taken.

PERFORMANCE ORDER

1. Establish wheels in the provision of driving on a straight line and check liquid level, if necessary restore, having added to Cold tag on the tank probe.

2. Start the engine and after work on bystry single to the engine course check liquid level again, if necessary restore, having added to Cold tag on the tank probe.

3. Turn a wheel here and there against the stop, at the same time do not allow strong impact with limiters, hold a wheel at the end of each course. Air at the same time is removed from a contour of the hydraulic booster. At implementation of this procedure you watch liquid level.

4. Establish wheels in the provision of driving on a straight line and several minutes later stop the engine.

5. Again check the liquid level which has to be on the heated-up engine about the mark Hot in the tank probe. If necessary add.