Toyota Camry

1996-2001 of release

Repair and operation of the car



Toyota Camry
+ 1. Maintenance instruction
+ 1.2. Information before driving of the car
- 1.3. Independent maintenance
   1.3.1.2. Choice of engine oil
   1.3.1.3. Check of level of cooling liquid of the engine
   1.3.1.4. The choice like coolant
   1.3.1.5. Check and replacement of the filter of the air conditioner
   + 1.3.2. Wheels and tires
   - 1.3.3. Electric components
      1.3.3.1.2. Check of appearance of the rechargeable battery
      1.3.3.1.3. Check of liquid of the rechargeable battery
      1.3.3.1.4. Recharge of the rechargeable battery
      1.3.3.2. Fuses
   1.3.4. Water additive in a washer tank
   + 1.3.5. Replacement of lighting lamps
+ 1.4. Technical characteristics
+ 1.5. Several councils upon purchase of the car
+ 2. Maintenance
+ 3. Engines
+ 4. Cooling system
+ 5. Heating and ventilation
+ 6. Fuel system
+ 7. Exhaust system
+ 8. Transmission
+ 9. Running gear
+ 10. Brake system
+ 11. Body
+ 12. Electric equipment


3beb1f2e




1.3.3.2. Fuses

GENERAL INFORMATION

Arrangement of fuses (on some models)




If headlights or other electric components do not work, then check fuses. If any of them fused, they have to be replaced.

Switch off the switch of ignition and idle components. Take the suspicious fuse directly on yourself and check it.

Define what fuse creates a problem. On a cover of the block of fuses the name of a chain of each fuse is shown.

Fuses of A type can be taken out by means of a stripper.

If are not sure whether the fuse fused, try to replace the suspicious fuse with that which, you know, is serviceable.

If the fuse fused, establish new in a clip.

Install the fuse only with the nominal rate of the ampere loading specified on a cover of the block of fuses.

If there is no spare fuse, then in emergency situation it is possible to pull out the MIRROR-HEATER, DOME or A/C fuse which is insignificant for normal driving and to use it if it has the same nominal rate of the ampere loading.

At impossibility to use the fuse with the same ampere loading use that which has lower value, but as it is possible closer to nominal. If the ampere loading is lower, than specified, the fuse can fuse again, but it does not indicate some problem. Surely try to get the correct fuse as soon as possible and return replacing it back in an initial clip.

If the new safety lock at once fuses, it means existence of a problem in electric system. Address experts as soon as possible.


Prevention

Never use the fuse with higher nominal rate of the ampere loading or any other subject instead of the fuse. It can cause serious damage and lead to the fire.