Toyota Camry

1996-2001 of release

Repair and operation of the car



Toyota Camry
+ 1. Maintenance instruction
+ 1.2. Information before driving of the car
- 1.3. Independent maintenance
   1.3.1.2. Choice of engine oil
   1.3.1.3. Check of level of cooling liquid of the engine
   1.3.1.4. The choice like coolant
   1.3.1.5. Check and replacement of the filter of the air conditioner
   - 1.3.2. Wheels and tires
      1.3.2.2. Check and replacement of tires
      1.3.2.3. Shift of tires
      1.3.2.4. Installation of tires for the movement on snow and antisliding chains
      1.3.2.5. Replacement of wheels
   + 1.3.3. Electric components
   1.3.4. Water additive in a washer tank
   + 1.3.5. Replacement of lighting lamps
+ 1.4. Technical characteristics
+ 1.5. Several councils upon purchase of the car
+ 2. Maintenance
+ 3. Engines
+ 4. Cooling system
+ 5. Heating and ventilation
+ 6. Fuel system
+ 7. Exhaust system
+ 8. Transmission
+ 9. Running gear
+ 10. Brake system
+ 11. Body
+ 12. Electric equipment



3beb1f2e


1.3.2.5. Replacement of wheels

GENERAL INFORMATION

When it is necessary to replace wheels

If the wheel has damage, for example, a bend, cracks or strong corrosion, – it has to be replaced. Otherwise the tire can slide off a wheel or it will lead to loss of management.

Choice of wheels


Wheels have to be replaced with what have the same permissible load, diameter, width of a rim and a departure. The wheel of other size or type can negatively influence driving, service life of a wheel and the bearing, cooling of brakes, calibration of the speedometer / odometer, ability of a stop, aiming of headlights, bumper height, clearance of the car and an interval from the tire or a chain of antisliding to a body and the chassis.

Replacement by the used wheels is not recommended. Never use a tire tube in a wheel with leak which was designed for the tubeless tire.

Aluminum wheels

After passing by the car of the first 1600 km check that nuts of wheels were normally tightened.

If shift, repair or replacement of tires was carried out, check that nuts of wheels were still tightened after passing of 1600 km.

When using chains be careful not to damage aluminum wheels.

Use only the nuts of wheels and a wrench of Toyota intended for aluminum wheels.

When balancing wheels use only counterbalances of Toyota or equivalent to them and the plastic or rubber hammer.

As well as when using any wheels, periodically check aluminum wheels for damage. If it is, immediately replace a wheel.