Toyota Camry

1996-2001 of release

Repair and operation of the car



Toyota Camry
+ 1. Maintenance instruction
+ 1.2. Information before driving of the car
+ 1.3. Independent maintenance
+ 1.4. Technical characteristics
+ 1.5. Several councils upon purchase of the car
+ 2. Maintenance
- 3. Engines
   + 3.1.2. Check of a compression
   - 3.2. 6-cylinder two-row V6 3,0 engines of l
      3.2.2. Check of a compression
      3.2.3. Top Dead Point (TDP) of the N1 piston
      3.2.4. Covers of heads of cylinders
      3.2.5. Inlet collector
      3.2.6. Final collectors
      3.2.7. Gas-distributing belt and asterisks
      3.2.8. Forward epiploon of a bent shaft
      3.2.9. Epiploons of camshafts
      3.2.10. Camshafts and elevators of valves
      3.2.11. Heads of cylinders
      3.2.12. Oil pallet
      3.2.13. Oil pump
      3.2.14. Flywheel / drive plate
      3.2.15. Back epiploon of a bent shaft
      3.2.16. Fastenings of the engine
   + 3.3. Partition of engines
   + 3.4. Engine electric equipment
+ 4. Cooling system
+ 5. Heating and ventilation
+ 6. Fuel system
+ 7. Exhaust system
+ 8. Transmission
+ 9. Running gear
+ 10. Brake system
+ 11. Body
+ 12. Electric equipment


3beb1f2e




3.2.11. Heads of cylinders

Removal

PERFORMANCE ORDER
1. Disconnect a wire of the minus plug of the accumulator.
2. Merge cooling liquid.
3. Remove the top and lower sections of an inlet collector.
4. Remove final collectors.
5. Take off a gas-distributing belt, asterisks of camshafts and the top intermediate pulley.
6. Unscrew bolts of a back cover of a gas-distributing belt.
7. Pick up the phone of cooling liquid.
8. Remove camshafts.
9. Unscrew bolts and disconnect plaits of wires from back parts of heads.

10. Unscrew the drowned bolts of heads.

11. Weaken other bolts of heads in the sequence, the return sequence of their tightening shown in the drawing. Weaken bolts on a quarter of a turn at one time.
12. Remove heads.

Installation

PERFORMANCE ORDER
1. Carefully clean and wipe with acetone the joined surfaces of heads and the block of cylinders. If surfaces are scratched or damaged otherwise, then they need to be processed in a specialized workshop.
2. By means of a suitable tap clean carvings in the block of cylinders. By means of a suitable die clean bolts of heads of cylinders.
3. Establish new laying and establish one of heads.
4. Oil bolts pure engine.
5. Insert bolts and tighten them till the required moment of an inhaling of the first step in the specified sequence. Do not tighten the drowned bolt.
6. Hold on bolts for 90 ° and tighten the drowned bolt.
7. Similarly establish other head.
8. Establish the remained details.