Toyota Camry

1996-2001 of release

Repair and operation of the car

Toyota Camry
+ 1. Maintenance instruction
+ 1.2. Information before driving of the car
+ 1.3. Independent maintenance
+ 1.4. Technical characteristics
+ 1.5. Several councils upon purchase of the car
+ 2. Maintenance
- 3. Engines
   + 3.1.2. Check of a compression
   - 3.2. 6-cylinder two-row V6 3,0 engines of l
      3.2.2. Check of a compression
      3.2.3. Top Dead Point (TDP) of the N1 piston
      3.2.4. Covers of heads of cylinders
      3.2.5. Inlet collector
      3.2.6. Final collectors
      3.2.7. Gas-distributing belt and asterisks
      3.2.8. Forward epiploon of a bent shaft
      3.2.9. Epiploons of camshafts
      3.2.10. Camshafts and elevators of valves
      3.2.11. Heads of cylinders
      3.2.12. Oil pallet
      3.2.13. Oil pump
      3.2.14. Flywheel / drive plate
      3.2.15. Back epiploon of a bent shaft
      3.2.16. Fastenings of the engine
   + 3.3. Partition of engines
   + 3.4. Engine electric equipment
+ 4. Cooling system
+ 5. Heating and ventilation
+ 6. Fuel system
+ 7. Exhaust system
+ 8. Transmission
+ 9. Running gear
+ 10. Brake system
+ 11. Body
+ 12. Electric equipment

3.2.6. Final collectors

Removal

PERFORMANCE ORDER

1. Disconnect a wire of the minus plug of the accumulator.
2. Oil bolts of collectors impregnating.
3. Remove oxygen sensors from both collectors.
4. Disconnect a tube of system of recirculation of final gases from a back collector and a head of cylinders.
	5. Twist nuts, the fixing exhaust pipes to collectors.
6. Unscrew bolts and remove collectors.
7. Examine collectors on existence of cracks and other damages.
8. Carefully clean the joined surfaces of a collector and a head of cylinders. If you found out that laying of a collector proceeded, check whether the collector is deformed, if necessary address the expert.

Installation

PERFORMANCE ORDER

1. Establish new laying.

2. Establish a collector and twist bolts.

3. Tighten bolts till the required inhaling moment.

4. Establish the remained details, start the engine and check final system for existence of leaks