Toyota Camry

1996-2001 of release

Repair and operation of the car

Toyota Camry
+ 1. Maintenance instruction
+ 1.2. Information before driving of the car
+ 1.3. Independent maintenance
+ 1.4. Technical characteristics
+ 1.5. Several councils upon purchase of the car
+ 2. Maintenance
- 3. Engines
   + 3.1.2. Check of a compression
   + 3.2. 6-cylinder two-row V6 3,0 engines of l
   - 3.3. Partition of engines
      3.3.1.2. 6-cylinder two-row engines
      3.3.2. Capital repairs of the engine – general comments
      3.3.3. Diagnostics of the engine by means of the vacuum gage
      3.3.4. Capital repairs of the engine – an alternative
      3.3.5. Auxiliary elements of the engine
      3.3.6. Removal and installation of the engine
      3.3.7. Engine partition
      3.3.8. Head of cylinders and valves
      3.3.9. Balancing device (4-cylinder engine)
      3.3.10. Pistons and rods
      3.3.11. Bent shaft
      3.3.12. Block of cylinders
      3.3.13. Honingovaniye of cylinders
      3.3.14. Radical bearings and bearings of rods
      3.3.15. Measurement of size of a free wheeling of the balancing device
      3.3.16. Piston rings
      3.3.17. Radical bearings of a bent shaft
      3.3.18. Back epiploon of a bent shaft
      3.3.19. Conrod bearings
      3.3.20. Installation of the balancing device of the engine
      3.3.21. It is rather live, than is dead …
      3.3.22. Analysis of smoke of an exhaust
      3.3.23. A gear belt for the gas distribution mechanism drive
      3.3.24. Emergence in deposit oil
      3.3.25. Engine overheat
   + 3.4. Engine electric equipment
+ 4. Cooling system
+ 5. Heating and ventilation
+ 6. Fuel system
+ 7. Exhaust system
+ 8. Transmission
+ 9. Running gear
+ 10. Brake system
+ 11. Body
+ 12. Electric equipment

3.3.20. Installation of the balancing device of the engine

PERFORMANCE ORDER

1. Clean the surfaces of the block of cylinders and the balancing device, establish laying.
2. Install the first piston in the top dead point.
3. Combine tags (deepening) on shaft with the cuts corresponding to them in a casing of shaft.
	4. Install the balancing device on the block and insert bolts. Tighten bolts till the required inhaling moment in the specified sequence.
5. Measure trailer gaps of shaft by means of the special measuring instrument. If gaps exceed the most admissible limits, address the expert.
	6. Measure a district gap of the tooth gearing of a shaft of N1 in four various provisions (1 – a gear wheel of a bent shaft, 2 – N1 shaft gear wheel).
	7. Combine a tag And N1 shaft with a cut in a casing and measure a district gap (1 – the top half of a casing, 2 – N1 shaft).
	8. Combine a tag In N1 shaft with a cut in a casing and measure a district gap.
9. If the free wheeling of a shaft exceeds admissible limits, adjust its size by means of adjusting laying.