Toyota Camry

1996-2001 of release

Repair and operation of the car

Toyota Camry
+ 1. Maintenance instruction
+ 1.2. Information before driving of the car
+ 1.3. Independent maintenance
+ 1.4. Technical characteristics
+ 1.5. Several councils upon purchase of the car
+ 2. Maintenance
+ 3. Engines
+ 4. Cooling system
+ 5. Heating and ventilation
+ 6. Fuel system
+ 7. Exhaust system
+ 8. Transmission
- 9. Running gear
   - 9.1.2. Technical characteristics
      9.1.3. Stabilizer of cross stability of a forward suspension bracket
      9.1.4. Rack of a forward suspension bracket
      9.1.5. Rack and spring of a suspension bracket
      9.1.6. Suspension bracket lever
      9.1.7. Spherical support
      9.1.8. Rotary fist and nave
      9.1.9. Nave and bearing of a forward wheel
      9.1.10. Stabilizer and plugs of the stabilizer of a back suspension bracket
      9.1.11. Rack of a back suspension bracket
      9.1.12. Longitudinal bar
      9.1.13. Levers of a back suspension bracket
      9.1.14. Nave and bearing of a back wheel
      9.1.15. Arm of a back suspension bracket
      9.1.16. Angles of installation of wheels
   + 9.2. Steering
   + 9.3. Half shafts
+ 10. Brake system
+ 11. Body
+ 12. Electric equipment

9.1.10. Stabilizer and plugs of the stabilizer of a back suspension bracket

Removal

PERFORMANCE ORDER

1. Release nuts of a back wheel, lift a back part of the car and remove a wheel.
2. Remove the heat-insulating guard of an exhaust pipe.
	3. Disconnect from a draft stabilizer bar, having turned off nuts. At a provorachivaniye of a hairpin record it a six-sided key.
	4. Turn off bolts of fastening of collars of plugs of the stabilizer.
5. Remove a stabilizer bar. Remove collars with rubber plugs.
6. Check a condition of plugs If on plugs damages are found (cracks, rubber hardening, strong deformations), then replace plugs. Check a condition of hinges of drafts of the stabilizer (see subsection 9.1.3.).
7. Clear the place of a prileganiye of plugs on a bar of dirt and a rust. Establish all details upside-down. If necessary grease new plugs and collars with culinary vegetable oil. It is forbidden to oil plugs at assembly on an oil basis or brake fluid in order to avoid a premature exit of plugs out of operation.

Installation

The stabilizer is installed upside-down.