Toyota Camry
+ 1. Maintenance instruction
+ 1.2. Information before driving of the car
+ 1.3. Independent maintenance
+ 1.4. Technical characteristics
+ 1.5. Several councils upon purchase of the car
+ 2. Maintenance
+ 3. Engines
+ 4. Cooling system
+ 5. Heating and ventilation
+ 6. Fuel system
+ 7. Exhaust system
+ 8. Transmission
- 9. Running gear
- 9.1.2. Technical characteristics
9.1.3. Stabilizer of cross stability of a forward suspension bracket
9.1.4. Rack of a forward suspension bracket
9.1.5. Rack and spring of a suspension bracket
9.1.6. Suspension bracket lever
9.1.7. Spherical support
9.1.8. Rotary fist and nave
9.1.9. Nave and bearing of a forward wheel
9.1.10. Stabilizer and plugs of the stabilizer of a back suspension bracket
9.1.11. Rack of a back suspension bracket
9.1.12. Longitudinal bar
9.1.13. Levers of a back suspension bracket
9.1.14. Nave and bearing of a back wheel
9.1.15. Arm of a back suspension bracket
9.1.16. Angles of installation of wheels
+ 9.2. Steering
+ 9.3. Half shafts
+ 10. Brake system
+ 11. Body
+ 12. Electric equipment
9.1.16. Angles of installation of wheels
| GENERAL INFORMATION |
Disorder of wheels, longitudinal and cross tilt angles of an axis of turn are provided with a design of a suspension bracket and are not subject to adjustment.
It is independently allowed to regulate a convergence of forward and back wheels and a limit angle of rotation of wheels though these procedures are recommended to be performed with high precision in car service.
The convergence of wheels is checked on a difference of distances between extreme points on disks of the wheels measured at the level of the center of wheels (measurements are carried out with a dry mass of the car when pressure in tires meets standard, and the car is parked on the flat horizontal platform). At first the distance is measured in a back part of wheels, then the car is rolled on 180 ° and the distance between the same points is measured in their forward part. For increase in accuracy it is recommended to measure a convergence on 3 points located on a wheel disk circle through 120 ° and to define an average convergence.
