Toyota Camry

1996-2001 of release

Repair and operation of the car

Toyota Camry
+ 1. Maintenance instruction
+ 1.2. Information before driving of the car
+ 1.3. Independent maintenance
+ 1.4. Technical characteristics
+ 1.5. Several councils upon purchase of the car
+ 2. Maintenance
+ 3. Engines
+ 4. Cooling system
+ 5. Heating and ventilation
+ 6. Fuel system
+ 7. Exhaust system
+ 8. Transmission
- 9. Running gear
   - 9.1.2. Technical characteristics
      9.1.3. Stabilizer of cross stability of a forward suspension bracket
      9.1.4. Rack of a forward suspension bracket
      9.1.5. Rack and spring of a suspension bracket
      9.1.6. Suspension bracket lever
      9.1.7. Spherical support
      9.1.8. Rotary fist and nave
      9.1.9. Nave and bearing of a forward wheel
      9.1.10. Stabilizer and plugs of the stabilizer of a back suspension bracket
      9.1.11. Rack of a back suspension bracket
      9.1.12. Longitudinal bar
      9.1.13. Levers of a back suspension bracket
      9.1.14. Nave and bearing of a back wheel
      9.1.15. Arm of a back suspension bracket
      9.1.16. Angles of installation of wheels
   + 9.2. Steering
   + 9.3. Half shafts
+ 10. Brake system
+ 11. Body
+ 12. Electric equipment

9.1.4. Rack of a forward suspension bracket

GENERAL INFORMATION

Prevention

Shock-absorbers of racks change only in couple.

Removal

PERFORMANCE ORDER

1. Lift a forward part of the car and establish on supports. Remove forward wheels. Substitute a jack under the suspension bracket lever.
	2. Disconnect a hydraulic actuator tube arm from a rack.
3. On the cars equipped with ABS system turn off a bolt of a collar of conducting and disconnect conducting from the speed sensor.
	4. Turn off the specified nuts of fastening of a rack to a rotary fist and the hammer and to small beards beat out bolts.
5. Disconnect a rack from a rotary fist. Take measures to damaging a cover of the internal CV JOINT, and also do not allow falling of a fist as at the same time the brake hose will be damaged.
	6. Holding the top part of a rack, turn off three nuts of fastening to a cap of a suspension bracket (arrow) and get a rack from a wheel niche.

Check

PERFORMANCE ORDER

1. Check existence on the case of a rack of cracks and other visible damages.

2. Check a condition of a spring, existence on rounds of cracks of a covering (leads to a premature exit of a spring out of operation owing to aging), hardening and damages on the isolating laying of a spring.

3. At detection of damages sort a rack and replace the damaged details.

Installation

PERFORMANCE ORDER

1. Working together, establish a rack so that hairpins entered openings of a cap and screw nuts.

2. Bring a rack flange to a rotary fist, insert bolts and screw nuts. Tighten nuts with the set moment.

3. Fix a hose arm on a rack. Attach the socket to the speed sensor.

4. Establish a wheel and lower the car.

5. Tighten three nuts of the top fastening of a rack.