Toyota Camry

1996-2001 of release

Repair and operation of the car

Toyota Camry
+ 1. Maintenance instruction
+ 1.2. Information before driving of the car
+ 1.3. Independent maintenance
+ 1.4. Technical characteristics
+ 1.5. Several councils upon purchase of the car
+ 2. Maintenance
+ 3. Engines
+ 4. Cooling system
+ 5. Heating and ventilation
+ 6. Fuel system
+ 7. Exhaust system
+ 8. Transmission
- 9. Running gear
   - 9.1.2. Technical characteristics
      9.1.3. Stabilizer of cross stability of a forward suspension bracket
      9.1.4. Rack of a forward suspension bracket
      9.1.5. Rack and spring of a suspension bracket
      9.1.6. Suspension bracket lever
      9.1.7. Spherical support
      9.1.8. Rotary fist and nave
      9.1.9. Nave and bearing of a forward wheel
      9.1.10. Stabilizer and plugs of the stabilizer of a back suspension bracket
      9.1.11. Rack of a back suspension bracket
      9.1.12. Longitudinal bar
      9.1.13. Levers of a back suspension bracket
      9.1.14. Nave and bearing of a back wheel
      9.1.15. Arm of a back suspension bracket
      9.1.16. Angles of installation of wheels
   + 9.2. Steering
   + 9.3. Half shafts
+ 10. Brake system
+ 11. Body
+ 12. Electric equipment

9.1.8. Rotary fist and nave

Removal

PERFORMANCE ORDER

1. Release a nave nut (see subsection 9.1.14.). Release wheel nuts, lift the car and remove a wheel.
2. Remove a support of a brake and fix by a wire (see subsection 10.5.). Remove a support arm, remove a brake disk from a nave.
3. Release (but do not turn off) bolts of fastening are resistant to a rotary fist.
4. Disconnect a tip of steering draft from a rotary fist (see subsection 9.2.3.).

5. Turn off bolts and nuts of fastening of a spherical support to the lower lever of a suspension bracket. Now turn off bolts of fastening of a rack to a rotary fist.
6. Push out a half shaft from a nave (see subsection 9.3.2.). Fix the end of a half shaft.
7. Separate a rotary fist from a rack. If necessary remove a spherical support.

Installation

PERFORMANCE ORDER

1. Establish a rotary fist and a nave on places, insert a half shaft.

2. Implant a rotary fist into a rack flange. Wrap nuts and bolts, but do not tighten.

3. Attach a spherical support to the lower lever of a suspension bracket, wrap bolts and nuts of fastening, without tightening them.

4. Attach a tip of steering thirst to a rotary fist. Tighten bolts and nuts of fastening are resistant, fastenings of a spherical support to the lever and a nut of a tip of steering draft with the set moments.

5. Establish a brake support (see subsection 10.5.) and a brake disk (see subsection 10.6.).

6. Establish a nave, tighten a nut.

7. Establish a wheel and wrap nuts.

8. Lower the car, tighten wheel nuts with the set moment. Tighten a nave nut with the set moment.