| 1. Remove the generator. |
| 2. Turn off nuts of a back cover, a generator conclusion nut. |
|
3. Remove the insulating plug of a conclusion of the generator. |
|
4. Remove a back cover of the generator. |
|
|
| 5. Unscrew screws and remove the brush holder and the regulator of tension. |
|
6. Measure length of the acting part of brushes. If length of a brush is less maximum permissible, then assembled with brushes replace the brush holder. |
| 7. Make sure that brushes freely move in the brush holder. |
| 8. Install tension regulator |
|
9. Install the brush holder for what wring out brushes. |
| 10. Insert brush holder screws into a back cover. |
| 11. Establish a cover and tighten nuts, install the plug and tighten a nut. |
| 12. Install the generator. |