Toyota Camry

1996-2001 of release

Repair and operation of the car



Toyota Camry
+ 1. Maintenance instruction
+ 1.2. Information before driving of the car
+ 1.3. Independent maintenance
+ 1.4. Technical characteristics
+ 1.5. Several councils upon purchase of the car
+ 2. Maintenance
- 3. Engines
   + 3.1.2. Check of a compression
   + 3.2. 6-cylinder two-row V6 3,0 engines of l
   + 3.3. Partition of engines
   - 3.4. Engine electric equipment
      3.4.2. Technical characteristics
      3.4.3. Rechargeable battery
      3.4.4. Power cables
      3.4.5. System of ignition
      3.4.6. Coil (i) of ignition
      3.4.7. Check of the moment of ignition
      3.4.8. Block of electronic ignition
      3.4.9. System of a charge of the battery
      3.4.10. Generator
      3.4.11. Regulator of tension and brush
      3.4.12. System of launch of the engine
      3.4.13. Starter electric motor
      3.4.14. Traction relay
      3.4.15. Main malfunctions of electric equipment
      3.4.16. What should be known to the owner of the car with the injector engine
      3.4.17. Turbo doctor
+ 4. Cooling system
+ 5. Heating and ventilation
+ 6. Fuel system
+ 7. Exhaust system
+ 8. Transmission
+ 9. Running gear
+ 10. Brake system
+ 11. Body
+ 12. Electric equipment


3beb1f2e




3.4.7. Check of the moment of ignition

GENERAL INFORMATION

Prevention

The procedure of installation of the moment of ignition is applicable almost to all cars considered in this manual. If the order of installation of ignition specified in the podkapotny plate of the car differs from described below, then be guided by the instruction of the plate. The ignition moment on all considered cars is not regulated therefore, at violation of installation of ignition it is necessary to check serviceability of units of system of ignition.


PERFORMANCE ORDER
1. Connect a tachometer, being guided by the instruction of the manufacturer of the device.
2. Find the diagnostic socket and close накоротко conclusions of E1 and TE1.
3. At the switched-off ignition connect a stroboscope, being guided by the instruction of the manufacturer of the device.
4. Find tags of the moment of ignition (shooter) on a forward cover and on a crankshaft pulley.
5. Warm up the engine, be convinced that turns of idling of the engine of 700 rpm on the car from the manual transmission and 750 rpm on the car with automatic transmission. Direct stroboscope light to a scale. The tag on a pulley of the crankshaft has to be opposite to the corresponding division of a scale.