Toyota Camry

1996-2001 of release

Repair and operation of the car

Toyota Camry
+ 1. Maintenance instruction
+ 1.2. Information before driving of the car
+ 1.3. Independent maintenance
+ 1.4. Technical characteristics
+ 1.5. Several councils upon purchase of the car
+ 2. Maintenance
+ 3. Engines
+ 4. Cooling system
+ 5. Heating and ventilation
+ 6. Fuel system
+ 7. Exhaust system
+ 8. Transmission
+ 9. Running gear
+ 10. Brake system
- 11. Body
   11.2. Vinyl finishing
   11.3. Upholstery and rugs
   11.4. Insignificant damages of a body
   11.5. Considerable damages of a body
   11.6. Loops and locks
   11.7. Windshield and motionless glasses
   11.8. Central lock
   11.9. Cowl
   11:10. Lock of a cowl and cable of the drive of the lock
   11:11. Decorative panels of bumpers
   11:12. Forward wing
   11:13. Trunk lid
   11:14. Latch and lock of a trunk lid
   11:15. Cable of the drive of unlocking of a door of a fuel tank / trunk lid
   11:16. Facing panels of doors
   11:17. Door
   11:18. Latch, lock of a door and handle
   11:19. Door glass
   11:20. Window regulator
   11:21. Mirrors
   11:22. Central floor section
   11:23. Decorative panels of a forward part of facing of salon
   11:24. Casings of a steering column
   11:25. Dashboard
   11:26. Facing of a frame of a windshield
   11:27. Seats
   11:28. Ware tray
+ 12. Electric equipment

11:15. Cable of the drive of unlocking of a door of a fuel tank / trunk lid

PERFORMANCE ORDER

1. Disconnect a cable and remove a trunk lid latch (see subsection 11.14.).
	2. For access to a cable of a door of a mouth of a tank remove a rug of a luggage carrier and the left sidewall of facing. Turn a cable tip counterclockwise on 1/4 turns and get from an arm (Camry model).
	3. On the Avalon models get a cable tip from an arm and bring out of gearing with the locking tank mouth door mechanism.
4. Remove the lower part of a back seat (see subsection 11.27.). On two-door models (coupe) it is necessary to remove a back and the lower part of a seat.
5. Hook and remove an overlay of powder of a door of the driver. On 4-door models remove the lower facing of the central side rack of a body.
6. Raise a floor mat and remove all latches of fastening of a cable to a body.
	7. Unscrew two screws of fastening of the handle of a cable to a floor.
	8. Raise the case and disconnect covers of cables from brackets and eyes on levers.
9. Attach a piece of a wire of sufficient length to a cable.
10. Stretch a cable from a luggage carrier to a wire exit.
11. Attach a new cable to a wire and stretch a new cable to the lever for a wire.
12. Further installation is carried out upside-down.