Toyota Camry

1996-2001 of release

Repair and operation of the car

Toyota Camry
+ 1. Maintenance instruction
+ 1.2. Information before driving of the car
+ 1.3. Independent maintenance
+ 1.4. Technical characteristics
+ 1.5. Several councils upon purchase of the car
+ 2. Maintenance
+ 3. Engines
+ 4. Cooling system
+ 5. Heating and ventilation
+ 6. Fuel system
+ 7. Exhaust system
+ 8. Transmission
+ 9. Running gear
+ 10. Brake system
- 11. Body
   11.2. Vinyl finishing
   11.3. Upholstery and rugs
   11.4. Insignificant damages of a body
   11.5. Considerable damages of a body
   11.6. Loops and locks
   11.7. Windshield and motionless glasses
   11.8. Central lock
   11.9. Cowl
   11:10. Lock of a cowl and cable of the drive of the lock
   11:11. Decorative panels of bumpers
   11:12. Forward wing
   11:13. Trunk lid
   11:14. Latch and lock of a trunk lid
   11:15. Cable of the drive of unlocking of a door of a fuel tank / trunk lid
   11:16. Facing panels of doors
   11:17. Door
   11:18. Latch, lock of a door and handle
   11:19. Door glass
   11:20. Window regulator
   11:21. Mirrors
   11:22. Central floor section
   11:23. Decorative panels of a forward part of facing of salon
   11:24. Casings of a steering column
   11:25. Dashboard
   11:26. Facing of a frame of a windshield
   11:27. Seats
   11:28. Ware tray
+ 12. Electric equipment

11:21. Mirrors

EXTERNAL MIRRORS

PERFORMANCE ORDER

1. On cars with the electric drive of a mirror remove facing of a door and the water filter (see subsection 11.16.).
2. Hook and remove facing of a mirror from the inside of a door.
3. Disconnect the electric motor socket.
	4. Turn off three bolts of fastening of a mirror. Track the route of conducting and disconnect the mirror electric drive socket at doors. Remove a mirror.
5. Installation is carried out upside-down.

INTERNAL MIRROR

PERFORMANCE ORDER

	1. Insert an edge of the screw-driver wound by an adhesive tape into a mirror leg basis groove and push out an U-shaped spring hairpin by which the leg of a mirror keeps in the basis (the screw-driver at the same time has to come approximately on 18 mm).
2. At installation of a mirror insert a spring if it was removed. Insert a mirror into the basis and press.
3. If the plate of fastening of a mirror disappeared from a windshield, then it should be pasted special glue.