Toyota Camry

1996-2001 of release

Repair and operation of the car



Toyota Camry
+ 1. Maintenance instruction
+ 1.2. Information before driving of the car
+ 1.3. Independent maintenance
+ 1.4. Technical characteristics
+ 1.5. Several councils upon purchase of the car
+ 2. Maintenance
+ 3. Engines
+ 4. Cooling system
+ 5. Heating and ventilation
+ 6. Fuel system
+ 7. Exhaust system
+ 8. Transmission
+ 9. Running gear
+ 10. Brake system
+ 11. Body
- 12. Electric equipment
   - 12.1.2. Search of malfunctions
      12.1.3. Safety locks
      12.1.4. Fusible crossing points
      12.1.5. Breakers
      12.1.6. Relay
      12.1.7. Breaker of indexes of turn / alarm system
      12.1.8. A combination of switches on a steering column
      12.1.9. Lock of ignition and drum of the lock
      12.1.10. Dashboard switches
      12.1.11. Indexes of level of fuel and temperature of oil
      12.1.12. Guard of devices
      12.1.13. Screen wiper electric motor
      12.1.14. Receiver and loudspeakers
      12.1.15. Antenna
      12.1.16. Heater of back glass
      12.1.17. Lamps of headlights
      12.1.18. Headlights
      12.1.19. Case of a halogen headlight
      12.1.20. Sound signal
      12.1.21. Replacement of lamps
      12.1.22. Side mirrors with the electric drive
      12.1.23. System cruise control
      12.1.24. Window regulator electric drive
      12.1.25. Electric drive of door locks
      12.1.26. Safety cushions
   + 12.2. Electrical circuitries



3beb1f2e


12.1.13. Screen wiper electric motor

GENERAL INFORMATION

Presence of tension on the electric motor
When giving tension on a conclusion 5 (weight – a conclusion 4) the electric motor has to rotate with a small speed, and at a zapityvaniye of a conclusion 3 – with high speed.

Check


Prevention

Before performance of check find an arrangement of the corresponding wires, using the scheme (see subsection 12.2.17.). Keep in mind that power wires have brighter coloring and bigger diameter than wires of connection with weight.


At too reduced speed of brushes check a condition of the battery. If the battery is charged, then remove the electric motor of a screen wiper and check by hand freedom of movement of brushes. If necessary grease all hinged connections or repair. If this measure does not yield result, then check a condition of contacts, especially connections with weight. If all connections in the normal state, then the electric motor replace.

If the screen wiper does not work, then check a safety lock. If the safety lock is serviceable, then connect the electric motor to weight a separate crossing point. If the electric motor turns on, then repair connection with weight. Otherwise include a screen wiper and disconnect the electric motor socket.

Check presence of tension on the electric motor (see rice. Presence of tension on the electric motor). If tension is, then check the electric motor, having connected it to the battery through a thin delay. If the electric motor turns on, then check freedom of movement of draft. Otherwise replace the electric motor. In the absence of tension on the electric motor check tension on the switch. If there is no tension on the switch, then check conducting from a safety lock to the switch. If conducting is correct, then the switch is faulty.

If brushes work only at one speed, then check conducting and a chain between electric motor conclusions. If conducting is correct replace the switch.

If the frequency of work of brushes is not regulated, then check conducting between the electric motor and the switch. If conducting is correct, then replace the regulator.

If brushes do not come back to the parked situation at switching off, then check tension on the electric motor at the included ignition and the switched-off cleaner. If tension is, then the trailer switch in the electric motor is faulty. Replace the electric motor. If there is no tension, then check and repair conducting between a safety lock and the electric motor.

If brushes continue to work until ignition is switched off, then disconnect the socket from the switch. If brushes stop, then replace the switch. Otherwise the trailer switch in the electric motor is faulty. Replace the electric motor.

If brushes do not reach position of the parking, then check existence of the disturbing objects and jamming of draft. If everything is all right, check conducting between the electric motor and the switch. If conducting is correct, then replace the electric motor.

Replacement
PERFORMANCE ORDER
1. Remove facing of a frame of a windshield and levers of brushes.
2. In the Camry and Solara models unscrew bolts (A) and disconnect the screen wiper socket(s).
3. On the Avalon models remove a bracket (A), turn off a bolt (V) and disconnect the socket (C).
4. For removal of draft of a screen wiper on the Avalon models turn off the specified bolts.
5. Get the electric motor with drafts.
6. Turn off bolts and remove the electric motor.
7. Installation is carried out upside-down.