Toyota Camry

1996-2001 of release

Repair and operation of the car

Toyota Camry
+ 1. Maintenance instruction
+ 1.2. Information before driving of the car
+ 1.3. Independent maintenance
+ 1.4. Technical characteristics
+ 1.5. Several councils upon purchase of the car
+ 2. Maintenance
+ 3. Engines
+ 4. Cooling system
+ 5. Heating and ventilation
+ 6. Fuel system
+ 7. Exhaust system
+ 8. Transmission
+ 9. Running gear
+ 10. Brake system
+ 11. Body
- 12. Electric equipment
   - 12.1.2. Search of malfunctions
      12.1.3. Safety locks
      12.1.4. Fusible crossing points
      12.1.5. Breakers
      12.1.6. Relay
      12.1.7. Breaker of indexes of turn / alarm system
      12.1.8. A combination of switches on a steering column
      12.1.9. Lock of ignition and drum of the lock
      12.1.10. Dashboard switches
      12.1.11. Indexes of level of fuel and temperature of oil
      12.1.12. Guard of devices
      12.1.13. Screen wiper electric motor
      12.1.14. Receiver and loudspeakers
      12.1.15. Antenna
      12.1.16. Heater of back glass
      12.1.17. Lamps of headlights
      12.1.18. Headlights
      12.1.19. Case of a halogen headlight
      12.1.20. Sound signal
      12.1.21. Replacement of lamps
      12.1.22. Side mirrors with the electric drive
      12.1.23. System cruise control
      12.1.24. Window regulator electric drive
      12.1.25. Electric drive of door locks
      12.1.26. Safety cushions
   + 12.2. Electrical circuitries

12.1.16. Heater of back glass

GENERAL INFORMATION

The heater consists from thin a provolok, baked with the surface of glass.

Small destructions a provolok can be repaired independently.

Check

PERFORMANCE ORDER

1. Include ignition and a heater. If on a heater there is tension, but there is no heating, then arrive as follows.
	2. Dress the put strip of aluminum foil on the voltmeter probe and press down a finger to heater thread.
	3. If tension is equal in the center of thread to 6 V, thread is serviceable if tension is equal to 12 V, thread is torn off (the break takes place between the center of thread and weight). If voltage of 0 V, then thread it is torn off between the center and the feeding heater conclusion.
4. If threads are serviceable, then connect (-) – a heater conclusion to weight. If indications of the voltmeter change, then connection with weight unsatisfactory.
	5. The place of break of thread can be established conducting aluminum contact on the voltmeter probe on thread aside from (+) – a conclusion to (-) – to a heater conclusion. The indication of the voltmeter has to fall in the place of break from several volts to 0.

Repair

PERFORMANCE ORDER

1. It is possible to splice the torn-off heater thread by means of the special epoxy carrying-out structure (is available on sale).
2. Disconnect a heater and wait for full cooling.
3. A steel sponge carefully to a raspoliruyta also wipe the damaged site with alcohol.
4. Impose on the damaged site a mask from an adhesive tape.
5. Prepare pitch, being guided by the instruction.
	6. Apply structure on a crack in a mask, smearing approximately on 18 mm in both parties.
7. 24 hours later unmask.