Toyota Camry
+ 1. Maintenance instruction
+ 1.2. Information before driving of the car
+ 1.3. Independent maintenance
+ 1.4. Technical characteristics
+ 1.5. Several councils upon purchase of the car
+ 2. Maintenance
+ 3. Engines
+ 4. Cooling system
+ 5. Heating and ventilation
+ 6. Fuel system
+ 7. Exhaust system
+ 8. Transmission
+ 9. Running gear
+ 10. Brake system
+ 11. Body
- 12. Electric equipment
- 12.1.2. Search of malfunctions
12.1.3. Safety locks
12.1.4. Fusible crossing points
12.1.5. Breakers
12.1.6. Relay
12.1.7. Breaker of indexes of turn / alarm system
12.1.8. A combination of switches on a steering column
12.1.9. Lock of ignition and drum of the lock
12.1.10. Dashboard switches
12.1.11. Indexes of level of fuel and temperature of oil
12.1.12. Guard of devices
12.1.13. Screen wiper electric motor
12.1.14. Receiver and loudspeakers
12.1.15. Antenna
12.1.16. Heater of back glass
12.1.17. Lamps of headlights
12.1.18. Headlights
12.1.19. Case of a halogen headlight
12.1.20. Sound signal
12.1.21. Replacement of lamps
12.1.22. Side mirrors with the electric drive
12.1.23. System cruise control
12.1.24. Window regulator electric drive
12.1.25. Electric drive of door locks
12.1.26. Safety cushions
+ 12.2. Electrical circuitries
12.1.3. Safety locks
| GENERAL INFORMATION |
Arrangement of the block of safety locks (Avalon)
| The block of safety locks on the Avalon cars is mounted under the dashboard to the left of a steering column. |
Block of the relay and safety locks (Solara and Camry)
| On the Solara and Camry cars the uniform block of the relay and safety locks is located in a motor compartment. On the Avalon cars blocks of the relay and safety locks separate. |
Relay arrangement
| Some relays are mounted near a suspension bracket cap from the driver. |
Chains of electric equipment of the car are protected by safety locks, breakers or fusible crossing points. The assembly block of safety locks is mounted in salon or in a motor compartment, depending on year of release and model of the car.
Safety locks are established on contacts of knife type and get by hand.
| The fused safety lock easily is found on appearance. |
It is also possible to check tension on conclusions. The safety lock fused if the voltmeter shows tension. To replace a safety lock get faulty and insert new, having pushed it into a nest.
The rated current of a new safety lock has to correspond in accuracy to current of replaced. The rated current is specified on a safety lock. It is forbidden to use wire pieces instead of a safety lock. If the new safety lock immediately fuses, then find the reason and eliminate. As a rule burn-out is caused by short circuit of wires because of an isolation mastication.
