Toyota Camry

1996-2001 of release

Repair and operation of the car

Toyota Camry
+ 1. Maintenance instruction
+ 1.2. Information before driving of the car
+ 1.3. Independent maintenance
+ 1.4. Technical characteristics
+ 1.5. Several councils upon purchase of the car
+ 2. Maintenance
+ 3. Engines
+ 4. Cooling system
+ 5. Heating and ventilation
+ 6. Fuel system
+ 7. Exhaust system
+ 8. Transmission
+ 9. Running gear
+ 10. Brake system
+ 11. Body
- 12. Electric equipment
   - 12.1.2. Search of malfunctions
      12.1.3. Safety locks
      12.1.4. Fusible crossing points
      12.1.5. Breakers
      12.1.6. Relay
      12.1.7. Breaker of indexes of turn / alarm system
      12.1.8. A combination of switches on a steering column
      12.1.9. Lock of ignition and drum of the lock
      12.1.10. Dashboard switches
      12.1.11. Indexes of level of fuel and temperature of oil
      12.1.12. Guard of devices
      12.1.13. Screen wiper electric motor
      12.1.14. Receiver and loudspeakers
      12.1.15. Antenna
      12.1.16. Heater of back glass
      12.1.17. Lamps of headlights
      12.1.18. Headlights
      12.1.19. Case of a halogen headlight
      12.1.20. Sound signal
      12.1.21. Replacement of lamps
      12.1.22. Side mirrors with the electric drive
      12.1.23. System cruise control
      12.1.24. Window regulator electric drive
      12.1.25. Electric drive of door locks
      12.1.26. Safety cushions
   + 12.2. Electrical circuitries

12.1.18. Headlights

GENERAL INFORMATION

Prevention

It is necessary to check adjustment of headlights each 12 months, when replacing a headlight or after repair of a forward part of a body. The described procedure allows to adjust only approximately headlights, exact adjustment is carried out in car service.

Screen marking for adjustment of a beam of light of headlights

1. The line at distance from a floor to the center of headlights

2. Area of a light spot

3. The line at distance from an axis of symmetry of the car to the center of headlights
Distance of 25 ft = 7,5 m

4. Forward plane of a headlight

5. Axis of symmetry of the car

Adjustment

PERFORMANCE ORDER

	2. On the case of a halogen headlight 2 adjusting screws – screws horizontal (And) and vertical are provided (In) adjustments of headlights.
3. The simplest way of adjustment consists in installation of a bunch on a marking on the screen (wall).
4. Designate a tape of a cross hairs, corresponding to the centers of headlights.
5. Install the car in 7,5 m from a wall.
6. Adjustment is carried out at normal loading of the car and a thin tank.
7. Establish a bunch of passing beam of headlights so that the light spot settled down 5 cm below than a horizontal and verticals are 5 cm more right. For raising of a bunch rotate the screw clockwise and vice versa. The same concerns adjustment to the left-to the right. Turn on driving beam of headlights and adjust a bunch so that the spot was strictly on the vertical line, directly under a horizontal. Prevention To precisely expose bunches of driving and passing beam in such a way it can be impossible. In this case try to adjust more precisely passing beam with which it is necessary to go more often and on which traffic safety more depends.
8. As soon as possible adjust headlights in car service.