Toyota Camry

1996-2001 of release

Repair and operation of the car

Toyota Camry
+ 1. Maintenance instruction
+ 1.2. Information before driving of the car
+ 1.3. Independent maintenance
+ 1.4. Technical characteristics
+ 1.5. Several councils upon purchase of the car
+ 2. Maintenance
+ 3. Engines
+ 4. Cooling system
+ 5. Heating and ventilation
+ 6. Fuel system
+ 7. Exhaust system
+ 8. Transmission
+ 9. Running gear
+ 10. Brake system
+ 11. Body
- 12. Electric equipment
   - 12.1.2. Search of malfunctions
      12.1.3. Safety locks
      12.1.4. Fusible crossing points
      12.1.5. Breakers
      12.1.6. Relay
      12.1.7. Breaker of indexes of turn / alarm system
      12.1.8. A combination of switches on a steering column
      12.1.9. Lock of ignition and drum of the lock
      12.1.10. Dashboard switches
      12.1.11. Indexes of level of fuel and temperature of oil
      12.1.12. Guard of devices
      12.1.13. Screen wiper electric motor
      12.1.14. Receiver and loudspeakers
      12.1.15. Antenna
      12.1.16. Heater of back glass
      12.1.17. Lamps of headlights
      12.1.18. Headlights
      12.1.19. Case of a halogen headlight
      12.1.20. Sound signal
      12.1.21. Replacement of lamps
      12.1.22. Side mirrors with the electric drive
      12.1.23. System cruise control
      12.1.24. Window regulator electric drive
      12.1.25. Electric drive of door locks
      12.1.26. Safety cushions
   + 12.2. Electrical circuitries

12.1.7. Breaker of indexes of turn / alarm system

GENERAL INFORMATION

Arrangement of the breaker of indexes of turn / alarm system

The breaker of indexes of turn / the alarm system (is specified) by an arrow mounted on a plastic arm on a partition of a motor compartment behind the assembly block.

Check and replacement

PERFORMANCE ORDER

1. Normal operation of the breaker is followed by clicks. If one of indexes of turn does not work, and clicks are not listened, then it is necessary to check a lamp.

Prevention
If the frequency of interruptions suddenly decreases, then burn-out of a lamp is the reason.

2. If both indexes do not work, then burn-out of a safety lock, malfunction of the breaker, switch or weakening of contacts is the reason. If the safety lock fused, then check existence of short circuit of conducting, and only after this check establish a new safety lock.

3. For replacement of the breaker get it from an arm and disconnect the socket.

4. Track that the new breaker in accuracy corresponded to replaced.

5. Installation is carried out upside-down.