|
Toyota Camry1996-2001 of releaseRepair and operation of the car |
|
Toyota Camry + 1. Maintenance instruction + 1.2. Information before driving of the car + 1.3. Independent maintenance + 1.4. Technical characteristics + 1.5. Several councils upon purchase of the car + 2. Maintenance + 3. Engines + 4. Cooling system + 5. Heating and ventilation + 6. Fuel system + 7. Exhaust system + 8. Transmission + 9. Running gear + 10. Brake system + 11. Body - 12. Electric equipment - 12.1.2. Search of malfunctions 12.1.3. Safety locks 12.1.4. Fusible crossing points 12.1.5. Breakers 12.1.6. Relay 12.1.7. Breaker of indexes of turn / alarm system 12.1.8. A combination of switches on a steering column 12.1.9. Lock of ignition and drum of the lock 12.1.10. Dashboard switches 12.1.11. Indexes of level of fuel and temperature of oil 12.1.12. Guard of devices 12.1.13. Screen wiper electric motor 12.1.14. Receiver and loudspeakers 12.1.15. Antenna 12.1.16. Heater of back glass 12.1.17. Lamps of headlights 12.1.18. Headlights 12.1.19. Case of a halogen headlight 12.1.20. Sound signal 12.1.21. Replacement of lamps 12.1.22. Side mirrors with the electric drive 12.1.23. System cruise control 12.1.24. Window regulator electric drive 12.1.25. Electric drive of door locks 12.1.26. Safety cushions + 12.2. Electrical circuitries |
12.1.26. Safety cushions
On all cars 2 pillows, one of which (from the driver) is mounted in the central part of a wheel, and another – on the right side of the dashboard are provided. Also is a part of the system the block of sensors and management mounted on the center of the car before floor section. The safety module from the driver The packed pillow and the device of forcing (reactor) which is under a pillow is a part of the module and it is connected to it an opening through which gas at receipt of a signal is supplied. The signal is given on the cable winded in a flexible spiral around a wheel shaft irrespective of a wheel angle of rotation. The pillow is inflated with the nitrogen which is formed as a result of reaction of an oxide of copper and azid of sodium. The safety module from the passenger The device of forcing (reactor), the put pillow, the reactor and the facing panel enter into structure of the module located over a glove box. Passenger's pillow much more than driver's pillow. Exterior finish of a cover of a pillow coincides with finishing of the forward panel. The seam which breaks when forcing gas in a pillow is provided in a cover. Side pillows are established on cars of 1998-99, they are in seatbacks from the outer edge. The sensor is mounted in a body, in the lower part of a rack of a door. Block of sensors and diagnostics The block provides food and operation of a safety cushion even at the switched-off battery. The block checks a condition of a security system. The control lamp of system (AIR-BAG lamp) at first lights up and at serviceable system dies away. If the system is faulty, then the lamp continues to burn or blink (or the sound signal is distributed). In this case the car should be handed over immediately in car service for check. Prevention When performing any works near a steering column or any unit of system it is necessary to disconnect safety cushions. For this purpose execute the following: – expose wheels in the provision of driving on a straight line and transfer the ignition key to position of LOCK; At manipulations with a pillow container always you take the revetted side of a container in the direction from yourself. It is forbidden to put a container the revetted party down. It is forbidden to measure resistance of any unit of system of pneumosafety as operation of a pillow from the ohmmeter battery is possible. Before performance of welding works disconnect the socket of a safety cushion of yellow color which is located under a steering column about the socket of a combination of switches (from the driver) or a box for trifles (from the passenger). It is forbidden to throw out a container with a pillow. |
|