Toyota Camry

1996-2001 of release

Repair and operation of the car

Toyota Camry
+ 1. Maintenance instruction
+ 1.2. Information before driving of the car
+ 1.3. Independent maintenance
+ 1.4. Technical characteristics
+ 1.5. Several councils upon purchase of the car
+ 2. Maintenance
- 3. Engines
   - 3.1.2. Check of a compression
      3.1.3. Top Dead Point (TDP) of the N1 piston
      3.1.4. Cover of a head of cylinders
      3.1.5. Inlet collector
      3.1.6. Final collector
      3.1.7. Gas-distributing belt and asterisks
      3.1.8. Forward epiploon of a bent shaft
      3.1.9. Camshaft epiploon
      3.1.10. Camshafts and elevators of valves
      3.1.11. Head of cylinders
      3.1.12. Oil pallet
      3.1.13. Oil pump
      3.1.14. Flywheel / drive plate
      3.1.15. Back epiploon of a bent shaft
      3.1.16. Fastenings of the engine
   + 3.2. 6-cylinder two-row V6 3,0 engines of l
   + 3.3. Partition of engines
   + 3.4. Engine electric equipment
+ 4. Cooling system
+ 5. Heating and ventilation
+ 6. Fuel system
+ 7. Exhaust system
+ 8. Transmission
+ 9. Running gear
+ 10. Brake system
+ 11. Body
+ 12. Electric equipment

3.1.12. Oil pallet

Removal

PERFORMANCE ORDER

1. Disconnect a wire of the minus plug of the accumulator.
2. Lift and fix a forward part of the car.
3. Remove protective guards of the engine.
4. Merge engine oil and remove an oil filter.
5. Twist the nuts fixing forward section of an exhaust pipe to a final collector, unscrew the bolts fixing the catalytic converter to final system, remove an arm and remove forward section of an exhaust pipe. Remove fastening of a final collector.
	6. Unscrew bolts (shooters) and remove an arm of the block of cylinders and the transmission.
	7. Unscrew bolts and remove the oil pallet from the block of cylinders.

Installation

PERFORMANCE ORDER

1. Carefully clean and wipe with acetone the joined surfaces of the pallet and the block of cylinders, clean carvings in block openings. Check whether the pallet flange is bent, if necessary correct it.
2. Examine a maslozaborny branch pipe on existence of a contamination of cracks or other damages.
	3. Apply sealant on a pallet flange (And – in a flute, In – from opening inside).
4. Install the pallet and insert bolts. Tighten bolts till the required inhaling moment.
5. Establish the remained details, start the engine and check it for existence of leaks.