Toyota Camry

1996-2001 of release

Repair and operation of the car

Toyota Camry
+ 1. Maintenance instruction
+ 1.2. Information before driving of the car
+ 1.3. Independent maintenance
+ 1.4. Technical characteristics
+ 1.5. Several councils upon purchase of the car
+ 2. Maintenance
- 3. Engines
   - 3.1.2. Check of a compression
      3.1.3. Top Dead Point (TDP) of the N1 piston
      3.1.4. Cover of a head of cylinders
      3.1.5. Inlet collector
      3.1.6. Final collector
      3.1.7. Gas-distributing belt and asterisks
      3.1.8. Forward epiploon of a bent shaft
      3.1.9. Camshaft epiploon
      3.1.10. Camshafts and elevators of valves
      3.1.11. Head of cylinders
      3.1.12. Oil pallet
      3.1.13. Oil pump
      3.1.14. Flywheel / drive plate
      3.1.15. Back epiploon of a bent shaft
      3.1.16. Fastenings of the engine
   + 3.2. 6-cylinder two-row V6 3,0 engines of l
   + 3.3. Partition of engines
   + 3.4. Engine electric equipment
+ 4. Cooling system
+ 5. Heating and ventilation
+ 6. Fuel system
+ 7. Exhaust system
+ 8. Transmission
+ 9. Running gear
+ 10. Brake system
+ 11. Body
+ 12. Electric equipment

3.1.5. Inlet collector

Removal

PERFORMANCE ORDER

1. Disconnect a wire of the minus plug of the accumulator.
2. Weaken a clip, the fixing hose of the air filter to a throttle, remove the top part of the air filter, the resonator and a hose.
3. Disconnect cooling system hoses from a throttle and their zakuporta to avoid leak of cooling liquid.
4. Disconnect all ropes and wires fixed on an inlet collector.
	4. Not to mix hoses in installation time make on them tags.
	5. Release wires from clamps.
	6. Disconnect wires of grounding (arrow).
	7. Unscrew bolts of an arm of a collector (arrow).
	8. Disconnect wires from the coil, unscrew bolts (shooters) and remove a collector arm.
	9. Unscrew assembly bolts, twist nuts and disconnect a collector from the engine.

Installation

PERFORMANCE ORDER

	1. Carefully clean the joined surfaces of a collector and a head of cylinders. If you found out that laying of a collector proceeded, check whether the collector is deformed, if necessary address the expert.
2. Establish new laying, establish a collector and insert bolts.
3. Tighten bolts till the required inhaling moment.
4. Establish the remained details, check whether draft of the drive of a throttle freely functions, start the engine and check it for existence of leaks.