Toyota Camry

1996-2001 of release

Repair and operation of the car

Toyota Camry
+ 1. Maintenance instruction
+ 1.2. Information before driving of the car
+ 1.3. Independent maintenance
+ 1.4. Technical characteristics
+ 1.5. Several councils upon purchase of the car
+ 2. Maintenance
- 3. Engines
   - 3.1.2. Check of a compression
      3.1.3. Top Dead Point (TDP) of the N1 piston
      3.1.4. Cover of a head of cylinders
      3.1.5. Inlet collector
      3.1.6. Final collector
      3.1.7. Gas-distributing belt and asterisks
      3.1.8. Forward epiploon of a bent shaft
      3.1.9. Camshaft epiploon
      3.1.10. Camshafts and elevators of valves
      3.1.11. Head of cylinders
      3.1.12. Oil pallet
      3.1.13. Oil pump
      3.1.14. Flywheel / drive plate
      3.1.15. Back epiploon of a bent shaft
      3.1.16. Fastenings of the engine
   + 3.2. 6-cylinder two-row V6 3,0 engines of l
   + 3.3. Partition of engines
   + 3.4. Engine electric equipment
+ 4. Cooling system
+ 5. Heating and ventilation
+ 6. Fuel system
+ 7. Exhaust system
+ 8. Transmission
+ 9. Running gear
+ 10. Brake system
+ 11. Body
+ 12. Electric equipment

3.1.6. Final collector

Removal

PERFORMANCE ORDER

1. Disconnect a wire of the minus plug of the accumulator.
2. Disconnect wires from the oxygen sensor. If you establish a new collector, remove the sensor.
	3. Unscrew bolts (shooters) and remove the top heat-insulating collector guard.
4. Oil collector bolts impregnating.
5. Disconnect an exhaust pipe from a collector.
	6. Unscrew the bolt (shooter) of an arm of a collector located near a forward support of the engine. Remove an arm of a collector and the lower heat-insulating guard.
	7. Unscrew bolts (shooters), remove a collector and laying.

Installation

PERFORMANCE ORDER

1. Carefully clean the joined surfaces of a collector and a head of cylinders. If you found out that laying of a collector proceeded, check whether the collector is deformed, if necessary address the expert.

2. Establish new laying.

3. Establish a collector and twist bolts.

4. Tighten bolts till the required inhaling moment.

5. Establish the remained details, start the engine and check final system for existence of leaks.