Toyota Camry
+ 1. Maintenance instruction
+ 1.2. Information before driving of the car
+ 1.3. Independent maintenance
+ 1.4. Technical characteristics
+ 1.5. Several councils upon purchase of the car
+ 2. Maintenance
- 3. Engines
- 3.1.2. Check of a compression
3.1.3. Top Dead Point (TDP) of the N1 piston
3.1.4. Cover of a head of cylinders
3.1.5. Inlet collector
3.1.6. Final collector
3.1.7. Gas-distributing belt and asterisks
3.1.8. Forward epiploon of a bent shaft
3.1.9. Camshaft epiploon
3.1.10. Camshafts and elevators of valves
3.1.11. Head of cylinders
3.1.12. Oil pallet
3.1.13. Oil pump
3.1.14. Flywheel / drive plate
3.1.15. Back epiploon of a bent shaft
3.1.16. Fastenings of the engine
+ 3.2. 6-cylinder two-row V6 3,0 engines of l
+ 3.3. Partition of engines
+ 3.4. Engine electric equipment
+ 4. Cooling system
+ 5. Heating and ventilation
+ 6. Fuel system
+ 7. Exhaust system
+ 8. Transmission
+ 9. Running gear
+ 10. Brake system
+ 11. Body
+ 12. Electric equipment
|
Removal
| PERFORMANCE ORDER |
| 1. Lift and fix the car on support. Remove the transmission. |
| 2. Remove press a disk and a disk of a clutch coupling (for engines with the mechanical transmission). |
|
|
3. Make adjusting tags (arrows) on a flywheel and on a bent shaft. |
| 4. Unscrew flywheel bolts / a drive plate, if necessary block a flywheel the screw-driver. |
|
|
5. Remove a flywheel / a drive plate. Intermediate rings are installed in cars with the automatic transmission on both sides of a drive plate. When carrying out assembly, the opening in an intermediate ring has to coincide with a pin (it is specified by an arrow). |
|
Installation
| PERFORMANCE ORDER |
| 1. Clean a flywheel and examine its surface on existence of cracks, scratches and the burned sites. Small damages can be removed, having processed a surface an emery paper. Check whether there are no absent teeth and whether the flywheel is deformed. |
| 2. If necessary replace a back epiploon of a bent shaft. |
| 3. Establish a flywheel on a bent shaft, using the tags made during the procedure of removal. Apply the pressurizing structure on carvings of bolts and insert bolts. Tighten bolts till the required inhaling moment. |
|
|
|
